Advertisement
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. The covering can
be readily stripped from the unit before installation. After removing the covering, wash the interior and exterior surfaces using a warm,
mild soapy water solution and a sponge or cloth, rinse with clean water and dry thoroughly.
Casters
The unit comes with the Casters installed. Check to make sure that the Casters are tightly fastened to the cabinet base to prevent
damage to the base.
Location
When locating the freezer, convenience and accessibility are important considerations, but the following factors must be observed:
• The unit must be level.
• Allow at least 6 inches of space at both ends to allow for proper air flow through the louvered panels. The space above the unit should
be open to allow access to the product.
• Avoid placing the freezer next to ovens, heating elements or hot air sources that would affect the performance of the unit.
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to power. The
specifications on the data plate supersede any future discussion.
Your Silver King freezer is equipped with an eight (8) foot power cord. Any attempt to modify the plug will void the warranty, terminate
the manufacturers responsibility, and could result in serious injury.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a
hazard."
The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit and not plugged into an
extension cord.
Energy Rating
Your Silver King refrigerator has a class 4 energy rating. The refrigerator was tested at an ambient temperature of 30°C (86°F) at 55%
relative humidity.
2
Advertisement
