Table of Contents
Advertisement
Microphone mixing
\For\Southeast\Asia]
Enjoy microphone mixing from various music sources such as
cassette, disc, radio or portable audio equipment.
Preparation:
≥Lower the microphone volume with [jMIC VOLi] on the
main unit, then connect the microphone(s) to the
microphone jack(s).
Every time you press the [jMIC VOLi] buttons:
MIC 1 ,. MIC 2 ,. MIC 3 ,. MIC 4
Use a dynamic microphone.
Plug type: Φ6.3 mm monaural.
≥If a strange noise (howling) is emitted during use, move the
microphone away from the speakers, or lower the
microphone volume.
≥When you are not using the microphone, disconnect it from
the microphone jack, and lower the microphone volume to
"MIC 1".
1
Select the music source:
≥When singing along with discs
Insert the desired disc (l page 12).
≥When singing along with cassette tape
Press deck 1 [<, OPEN] on the main unit and insert the
desired cassette tape (l page 25).
≥When singing along with radio
Select your desired station (l page 24).
≥When singing along with a portable audio
equipment
Connect and prepare the portable audio equipment
(l page 29).
2
Start singing and adjust volume with [jVOLUMEi]
and [jMIC VOLi] on the main unit.
Record microphone mixing
\For\Southeast\Asia]
Preparation:
≥Do the preparatory steps 1 and 2 on page 25, Recording.
1
Press deck 2 [OPEN, <] on the main unit and insert a
cassette tape.
2
Select the music source (l see above) and press [∫].
3
Press [¥, RECORD] on the main unit and start
microphone mixing.
To stop recording
Press [∫].
26
RQTV0141
To record your voice
\For\Southeast\Asia]
Preparation:
≥Do the preparatory steps 1 and 2 on page 25, Recording.
≥Ensure that there is no tape in deck 1.
1
Press deck 2 [OPEN, <] on the main unit and insert a
cassette tape.
2
Press [¥, RECORD] on the main unit to start
recording.
3
Speak through the microphone and adjust volume
with [jVOLUMEi] and [jMIC VOLi] on the main
unit.
Adjusting the echo effect
\For\Southeast\Asia]
1
Press and hold [jECHO].
Current setting appears on the display.
2
While current setting is displayed
Press [jECHO] to change the setting.
Every time you press the button:
ECHO 1 ) ECHO 2 ) ECHO 3 ) ECHO 4
^--------------- ECHO OFF (off) !---------------}
[Note]
≥The effect increases with the level.
≥The setting will change only if you press [jECHO] right after
the current setting is displayed.
Advertisement
Table of Contents
