Table of Contents
Advertisement
8 en |
Re-assemble the IP board into the chassis.
3.) Secure all cabling.
Camera Setup:
To determine if the camera is receiving a picture:
1.) Make sure the supplied software is installed in your PC/laptop
computer (For Camera Configuration and Software Viewing
Setup, refer to full version Installation Manual available on the
enclosed CD-ROM -Section 4).
2.) Connect the camera to the PC/laptop and power up the camera.
Follow the prompts. See section 2 of full version Installation
Manual available on the enclosed CD-ROM for more detail.
MAN36IPB Rev.0 | 2008.10
"ON" (850nm LEDs will have a slight red glow). Adjust the
LED power if they are too bright or too dim. For IR power
adjustment, rotate VR1. Clockwise is high and counter-
clockwise is low.
2.4) Photocell adjustment
The photocell is factory set optimum level. In some condi-
tions such as with bright foreground objects the camera may
switch too early or too late. For photocell "On/Off" light-level
adjustment, rotate IR Adjustment Pot. Clockwise is off and
counter-clockwise is on.
2.5) Ethernet Connection.
Remove the two screws securing the Camera / LED
module from the camera housing. See the figure below.
Quick Install
Get other manuals https://www.bkmanuals.com
Ethernet
connector
Bosch Security Systems
EX36-IP
Advertisement
Table of Contents
