Table of Contents
Advertisement
EN 14
9 AUTOMATIC OVEN CLEANING (ONLY IN SOME MODELS)
The automatic cleaning function, where present, may vary according to which model is purchased.
PYRO CLEANING CYCLE
(IF PRESENT)
For the description of this function, see also the
functions table on page 18 and the chapter
"Cleaning" on page 24.
access special functions
turn
to select
press
to confirm.
turn
to select desired pre-set duration.
press
to run pyro cleaning cycle or press
go to set end time (section 6).
turn
to set the desired end time.
press
to start automatic oven cleaning.
note: during a Pyro-cleaning cycle, the oven door is
automatically locked.
Once the icon
disappears, the oven is once again
fully functional.
WARNING
- Do not touch the oven during the pyrolysis
cycle.
- Keep children away from the oven during the
pyrolysis cycle.
- Keep animals away during and after the
pyrolysis cycle.
.
.
SMARTCLEAN
For the description of this function see also the
functions table on page 18.
With the oven cold, distribute 200 ml of water on
the bottom of the oven cavity, then close the oven
door.
access special functions
turn
to select
press
to confirm.
press
to start immediately smartclean
cycle or press
section 6).
at the end of the cycle, remove any residual water
in the oven and start cleaning using a sponge
to
moistened with hot water (cleaning could be
compromised if delayed by more than 15 minutes).
to eliminate particularly stubborn grime, repeat
the smartclean
neutral detergent while removing the grime.
note: a smaller or greater amount of water could
compromise proper functioning of the cleaning cycle.
The duration of cleaning cycle cannot be set.
USING THE OVEN
CLEANING CYCLE
TM
(IF PRESENT)
.
.
to set end time/start delayed (see
cycle and add a few drops of
tm
tm
Advertisement
Table of Contents
