Table of Contents
Advertisement
A
Procedure
IIIIIIIIIIIIIIIIIIIIIIII
///////////////////////////////////////////////////////////////////////////////////////////////////////
///////////////////////////////////////////////////////////////////////////////////////////////////////
U
PGRADING
DPE 40
The DPE 40 module comes with two 16 MB 72-pin SIMMs of instruction and
data memory installed on the board. You can upgrade your memory by
replacing the 16 MB SIMMs with two 32 MB SIMMs. Refer to the release notes
shipped with this guide for approved memory chip models and vendors.
You must install SIMMs in pairs of equal-sized memory.
To upgrade your memory, complete the following:
1 Locate the memory sockets on your DPE module, as shown:
IIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIII
///////////////////////////////////////////////////////////////////////////////////////////////////////
///////////////////////////////////////////////////////////////////////////////////////////////////////
IIIIIIIIIIIII
IIIIIIIIIIIIIIIIIIIIIIIIIIII
M
EMORY FOR THE
IIIIIIIIIIIII
IIIIIIIIIIIII
Front panel
Memory sockets
Motherboard
Advertisement
Table of Contents
Need help?
Do you have a question about the NETBuilder II DPE 80 and is the answer not in the manual?
Questions and answers