Janome 3622S Instruction Book page 46

b
n m
,
.
!4
!1
!2
!3
b Depress the foot control to sew a buttonhole.
The machine will sew the front bartack, left
row, back bartack and right row automatically.
Stop the machine at the ending point.
!1 Ending point
n Raise the presser foot and cut the both needle
and bobbin threads leaving 10 cm (4˝) thread
ends.
Draw the needle thread to wrong side of the
fabric by pulling the bobbin thread.
Then, knot the threads.
m Remove the fabric and place a pin just before
the bartack at each end to prevent cutting
bartacks. Cut the opening with the seam
ripper.
!2 Pin
!3 Seam ripper
• To repeat buttonhole sewing
, To repeat buttonhole sewing, turn the stitch
selector to
shown.
Now, simply step on the foot control to sew an
identical buttonhole.
. When the buttonhole sewing is finished, push
the buttonhole lever upward as far as it will go.
!4 Buttonhole lever
• Adjusting buttonhole stitch density
Turn the stitch length dial to the right for a coarser
density.
Turn the stitch length dial to the left for a tighter
density.
44
, then back to again, as