Table of Contents
Advertisement
38
Adjustments
The machine is shipped perfectly adjusted. However during transit, some adjustments could be tweaked. If
one is found, follow these guides to resolve.
If you have any doubt about the described procedure, seek professional assistance. Do not
attempt any procedure that you feel is unsafe, or that you do not have the physical capability of achieving.
High / Low Speed Belt Change
Speed Range Cabinet
this procedure.
The lathe has two sets of pulleys for high (135 - 3500 RPM ) and low
(50 - 1300 RPM) speed ranges.
Adjust between the speed ranges as follows.
1. Disconnect the electric supply to the lathe.
2. Open the pulley cover.
3. Loosen the motor lock handle and lift the motor to the highest
position with the motor adjustment handle, then lock the motor
lock handle.
4. Move the drive belt to the required set of pulleys.
5. Loosen the motor lock handle and with the motor adjustment
handle tension the drive belt, then lock the motor lock handle.
The belt should be tensioned so that there is approximately 1/8 to 1/4
" deflection when the belt is pressed with moderate thump pressure.
Revo 18|36 Lathe \ Adjustments
Make sure the machine is unplugged with
no chance of turning on when performing
Advertisement
Table of Contents
