Am-Esp-S030-Xxxx / Am-Esp-S050-Xxxx Standard Type - Delta S Series Installation And Maintenance Instructions Manual

Delta Electric Servo Press - S Series
Installation and Maintenance Instructions
4.3.2
AM-ESP-S030-XXXX / AM-ESP-S050-XXXX Standard
Type
The fastening ports for attaching the servo press are shown in the figure below. Please use 4 general
M20X2.5 hex screws (JIS strength 12.9, length 80) and apply the tightening torque of 5600 kgf-cm.
Caution: Please note that the equipment has to be closely attached to the locking and fastening
platform while fastening the servo press.
14
Locking and fastening site