Installing & Cleaning Foam Wet Filter - MasterForce 240-5417 Operator's Manual

INSTALLING & CLEANING FOAM WET FILTER
INSTALLING FOAM WET FILTER
1. Verify that the power cord is disconnected
from the outlet (Fig. 1).
Fig. 1
2. Remove the power head and place in an
upside-down position. Follow instructions to
remove the cartridge filter on page 18.
3. Carefully slide foam wet filter down over
the filter cage making sure the cage is
completely covered (Fig. 2 & 3).
Fig. 2
4. Place the power head onto the collection
tank.
Fig. 3
CLEANING FOAM WET FILTER
1. With the removed power head in an upside-
down position, carefully remove the foam
wet filter (Fig. 4).
Fig. 4
2. Use a mild soap and water solution to wash
the foam wet filter and rinse with clean water
(Fig. 5).
Fig. 5
3. Allow the filter to air dry for 24 hours before
installing onto the filter cage.
Page 20