Liquid Vacuum Operation - MasterForce 240-5417 Operator's Manual

LIQUID VACUUMING
WARNING:
UNDERSTAND, AND APPLY INFORMATION
ENTITLED 'SAFETY INSTRUCTIONS &
WARNINGS'. DO NOT VACUUM IN AREAS
W I T H F LAM MABLE G AS E S, V AP OR S ,
O R E X P L O S I V E D U S T S I N T H E A I R .
FLAMMABLE GASES OR VAPORS INCLUDE
BUT ARE NOT LIMITED TO: LIGHTER
FLUID, SOLVENT TYPE CLEANERS, OIL-
BASED PAINTS, GASOLINE, ALCOHOL, OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS
INCLUDE BUT ARE NOT LIMITED TO: COAL,
MAGNESIUM, GRAIN, OR GUN POWDER.
T O R E D U C E T H E R I S K O F H E A L T H
HAZARDS FROM VAPORS OR DUST, DO
NOT VACUUM TOXIC MATERIALS.
WARNING:
C O R D I N T O P O W E R O U T L E T . M A K E
SURE PLUG IS DISCONNECTED BEFORE
CHANGING THE FILTERS.
1. Verify that the power cord is disconnected
from the outlet. Make sure that the collection
tank is clean and free of dust and dirt (Fig. 1).
Fig. 1
2.Remove the cartridge filter, then carefully
install the foam wet filter over the filter cage
and place the power head back on the
collection tank. For foam wet filter installation
instructions, see page 20 (Fig. 2).

LIQUID VACUUM OPERATION

B E S U R E T O R E A D ,
DO NOT PLUG POWER
Fig. 2
DO NOT USE THE CARTRIDGE FILTER FOR
LIQUID VACUUMING.
OPERATING INSTRUCTIONS: WET
VACUUMING
3. Push the required attachment onto the free
end of the hose or extension wand (Fig. 3).
Fig. 3
4. Verify that the on/off switch is in the 'O' OFF
position before plugging the power cord into
the outlet. Plug the power cord into the outlet
(Fig. 4 & 5).
Fig. 4
Page 12