Safety Tips ·Position on a flat, stable surface. ·A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components or service panels on this product. ·Consult Local and National Standards to comply with the following: ·Health and Safety at Work Legislation ·BS EN Codes of Practice ·Fire Precautions...
move by holding the base of the appliance. ·Always switch off and disconnect the power supply to the unit before cleaning. · Keep all packaging away from the children. Dispose of the packaging in accordance with the regulations of local authorities. ·If the power cord is damaged, it must be replaced by an agent or a recommended qualified technician in order to avoid a hazard.
We pride itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your dealer immediately. Installation Note: If the unit has been stores or moved in an upright position, let it stand upright for approximately 12 hours before operation.
Fit Glass Panels 1. Screw the collars to the rim of the appliance. Note: Ensure the hole in the collar for the grub screw faces inwards. 2. Slot the two sides panels into the collars, with the holes in the glass at the top.
Operation Storing Food To get the best results from your appliance, follow these instructions: 1. Only store foodstuffs in the appliance when it has reached the correct operating temperature. 2. Ensure gastronorm bays are full at all times, even if the gastronorms are unused or empty.
illuminates. The defrost will last a maximum of 30 minutes. Note: Starting a manual defrost also resets the automatic defrost timer. The next automatic defrost will start six hours after the manual defrost has finished. 3. Waste water is collected in the waste water tray. Cleaning, Care &...
Troubleshooting If your appliance develops a fault, please check the following table before call your dealer. Fault Probable Cause Action The appliance is not The unit is not switched on Check the unit is plugged in working. correctly and switched on Plug and lead are damaged Call your agent or qualified Technician...
standard. The plug is to be connected to a suitable mains socket. Appliance are wired as follows: ·Live wire ( colored brown ) to terminal marked L ·Neutral wire ( colored blue ) to terminal marked N ·Earth wire ( colored green/yellow ) to terminal marked E All appliances must be earthed, using a dedicated earthing circuit.
Page 13
Products have been approved to carry the following symbol: Hamoki Limited www.hamoki.co.uk...