Cisco TelePresence MX Series Administrator's Manual page 51

Cisco TelePresence MX Series
Contents
Cameras Camera [1..1] Gamma Mode
The Gamma Mode setting enables gamma corrections. Gamma describes the nonlinear
relationship between image pixels and monitor brightness.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: Auto is the default and the recommended setting.
Manual: In severe light conditions, you may switch mode to manual and specify explicitly
which gamma table to use by setting the Gamma Level.
Cameras Camera 1 Gamma Mode: Auto
Example:
Cameras Camera [1..1] Gamma Level
By setting the Gamma Level you can select which gamma correction table to use. This setting
may be useful in difficult lighting conditions, where changes to the brightness setting does not
provide satisfactory results. NOTE: Requires the Gamma Mode to be set to Manual.
Requires user role: ADMIN
Value space: <0..7>
Range: Select a value from 0 to 7.
Cameras Camera 1 Gamma Level: 0
Example:
Cameras Camera [1..1] IrSensor
Not applicable in this version.
Cameras Camera [1..1] Mirror
Not applicable in this version.
D14850.05 MX Series Administrator Guide TC6.1, APRIL 2013.
Introduction Web interface System settings System settings
Cameras Camera [1..1] Whitebalance Mode
Set the camera whitebalance mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will continuously adjust the whitebalance depending on the camera view.
Manual: Enables manual control of the camera whitebalance. The whitebalance level is set
using the Cameras Camera Whitebalance Level setting.
Cameras Camera 1 Whitebalance Mode: Auto
Example:
Cameras Camera [1..1] Whitebalance Level
Set the whitebalance level. NOTE: Requires the Camera Whitebalance Mode to be set to
manual.
Requires user role: ADMIN
Value space: <1..16>
Range: Select a value from 1 to 16.
Cameras Camera 1 Whitebalance Level: 1
Example:
www.cisco.com — Copyright © 2011–2013 Cisco Systems, Inc. All rights reserved.
51
Administrator Guide
Setting passwords Appendices