Cisco TelePresence MX Series Administrator's Manual page 50

Cisco TelePresence MX Series
Contents
Cameras settings
Cameras PowerLine Frequency
Applies to cameras supporting PowerLine frequency anti-flickering, i.e. PrecisionHD 1080p
cameras.
Requires user role: ADMIN
Value space: <50Hz/60Hz>
50Hz: Set to 50 Hz.
60Hz: Set to 60 Hz.
Cameras PowerLine Frequency: 50Hz
Example:
Cameras Camera [1..1] Backlight
This configuration turns backlight compensation on or off. Backlight compensation is useful
when there is much light behind the persons in the room. Without compensation the persons
will easily appear very dark to the far end.
Requires user role: ADMIN
Value space: <Off/On>
Off: Turn off the camera backlight compensation.
On: Turn on the camera backlight compensation.
Cameras Camera 1 Backlight: Off
Example:
Cameras Camera [1..1] Brightness Mode
Set the camera brightness mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera brightness is automatically set by the system.
Manual: Enable manual control of the camera brightness. The brightness level is set using
the Cameras Camera Brightness Level setting.
Cameras Camera 1 Brightness Mode: Auto
Example:
D14850.05 MX Series Administrator Guide TC6.1, APRIL 2013.
Introduction Web interface System settings System settings
Cameras Camera [1..1] Brightness Level
Set the brightness level. NOTE: Requires the Camera Brightness Mode to be set to Manual.
Requires user role: ADMIN
Value space: <1..31>
Range: Select a value from 1 to 31.
Cameras Camera 1 Brightness Level: 1
Example:
Cameras Camera [1..1] Flip
Not applicable in this version.
Cameras Camera [1..1] Focus Mode
Set the camera focus mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will auto focus once a call is connected, as well as after moving the
camera (pan, tilt, zoom). The system will use auto focus only for a few seconds to set the
right focus; then auto focus is turned off to prevent continuous focus adjustments of the
camera.
Manual: Turn the autofocus off and adjust the camera focus manually.
Cameras Camera 1 Focus Mode: Auto
Example:
Cameras Camera [1..1] FrameRate
Set the frame rate.
Requires user role: ADMIN
Value space: <60Hz/30Hz>
60Hz: Set the frame rate to 60 Hz.
30Hz: Set the frame rate to 30 Hz.
Cameras Camera 1 FrameRate: 30Hz
Example:
www.cisco.com — Copyright © 2011–2013 Cisco Systems, Inc. All rights reserved.
50
Administrator Guide
Setting passwords Appendices