Installing The So-Dimm Module - DFI ED700-EHL User Manual

Installing the SO-DIMM Module

Before installing the memory module, please make sure that the following safety cautions are
well-attended.
1. Make sure the PC and all other peripheral devices connected to it has been powered
down.
2. Disconnect all power cords and cables.
3. Locate the SO-DIMM socket on the system board
4. Make sure the notch on memory card is aligned to the key on the socket.
Retention Notch
Notch
Retention Clip
Key
User's Manual | ED700-EHL
DDR4 SO-DIMM
DDR4 SO-DIMM
Socket Top View
Retention Clip
Key
Please follow the steps below to install the memory card into the socket.
4 5 °
Step 1
Step 2
Step 3
Chapter 2
HARDWARE INSTALLATION
Socket Top View
Step 1:
Insert the memory card into the slot while
making sure 1) the notch and the key are
aligned, and 2) the non-connector end
rises approximately 45 degrees horizon-
tally. Press the card firmly into the socket
while applying and maintaining even pres-
sure on both ends.
Step 2:
Press the end of the card far from the
socket down while making sure the reten-
tion notch and the clip align as indicated
by the dotted line in the illustration. If the
retention notch and the clip do not align,
please remove the card and re-insert it.
Press the card all the way down.
Step 3:
The clips snap automatically and abruptly
to the retention notches of the card
sounding a distinctive click, and lock the
card in place. Inspect that the clip sits
in the notch. If not, please pull the clips
outward, release and remove the card, and
mount it again.
13