Installing An Antenna - DFI ED700-EHL User Manual

X Installing an Antenna
Before installing the antenna, please make sure that the following safety cautions are wellat-
tended.
1. Make sure the PC and all other peripheral devices connected to it has been
powered down.
2. Disconnect all power cords and cables.
Step 1:
There are antenna holes reserved on the front and left side of the system and covered by six
knockout tabs. Please remove the knockout tabs prior to installing an antenna.
Knockout tabs for antenna holes
Knockout tabs for antenna holes
User's Manual | ED700-EHL
Step 2:
Use a flathead screwdriver and apply a little extra force to detach a knockout tab until it
breaks off from the system.
Once the knockout tab is mostly detached, it will pretty quickly snap off, leaving you a nice
hole for installing an antenna.
Step 3:
Connect the internal cable to the board's antenna connector, screw the antenna connector
through the antenna hole with washers and nuts, and screw on the antenna as illustrated below.
Module Connector Cable Antenna Connector
Chapter 2
HARDWARE INSTALLATION
Antenna
Chassis Wall
Washer Nut
11