Advertisement
2. DISPLAY AND BUTTONS
2.1 DISPLAY
Information are displayed when the remote controller is power up.
Not applicable for this unit
Breeze Away display
Not applicable for this unit
Not applicable for this unit
ECO intelligent eye display
Transmission Indicator
Lights up when remote
sends signal to indoor unit
TIMER ON display
TIMER OFF display
Silence feature
display
FAN SPEED display
Displays selected fan speed:
1%
Silence
2%-20%
LOW
21%-40%
41%-60%
MED
61%-80%
HIGH
81%-100%
AUTO
This fan speed can not be
adjusted in AUTO or DRY
mode.
Note:
All indicators shown in the figure are for the purpose of clear presentation. But during the actual
operation, only the relative function signs are shown on the display window.
03
Active clean feature display
Fresh and UV(if any) feature display
Sleep mode display
Follow me feature display
Wireless control feature display
Low battery detection display(If flashes)
MODE display
Displays the current
mode,
including:
ECO display
Displays when ECO
feature is activated
GEAR display
Displays when GEAR
feature is activated
LOCK display
Displays when LOCK feature
is activated.
Temperature/Timer/Fan speed
Humidity display
Displays the set temperature
by default, or fan speed or
timer setting when using
TIMER ON/OFF functions.
Temperature range:
16-30 C /60-86 F
o
o
Horizontal louver
Timer setting range:
swing display
0-24 hours
Vertical louver auto
Fan speed setting range:
swing display
AU -100%
Turbo mode display
Humidity setting range:
35% -85%
Not applicalbe for
This display is blank when
this unit
operating in FAN mode.
2.2 BUTTONS
Mode
Press the mode button to
switch the mode in turn.
NOTE: HEAT mode is not supported
by the cooling only appliance.
On/Off
Press to start operation.
Press again to stop.
Temperature UP
Increases temperature in
0.5 C /1 F increments.
Max. Temp. is 30 C/86 F .
SET
Scrolls through operation
functions as follows:
Breeze away >Active clean>
*
Fresh/UV > Sleep> Follow Me
*
> AP mode
*
The selected symbol will flash on
the display area, press the OK
button to confirm.
[*]: Model dependent
OK
Used to confirm the selected
functions.
Fan Speed
Press to select the desired fan speed.
1%
Silence
2%-20%
LOW
21%-40%
41%-60%
MED
61%-80%
HIGH
81%-100%
AUTO
Turbo
Enables unit to reach preset
temperature in shortest possible
time.
NOTE: AUTO mode and HEAT mode are not available for Model RG10L1(U2HS)/BGCEF.
Eco Intelligent eye
Used to detect the people activities in
the room to save energy.
TIMER
Set timer to turn unit on or off.
Temperature Down
Decreases temperature in 0.5 C/1 F
increments. Min. Temp. is 16 C/60 F.
NOTE: Press together
&
buttons at the same time for 3 seconds
will alternate the temperature display
between the °C & °F.
Eco Gear
Press to enter the energy
efficient mode
Swing
Starts and stops the horizontal louver
movement. Hold down for 2 seconds
to initiate vertical louver auto swing
feature(some units).
Humidity
Adjust the room humidity during
Dry operation in a range of
35%~85%. Press this button to
increase the humidity in 5%
increments.
NOTE: After setting, the humidity
settings will display on the screen.
LED
Press to turn on/off the LED
display. Pressing 5 more
seconds to alternate the indoor
display between setting
temperature and room
temperature(Model dependent).
LOCK
Press together Turbo button and
Humidity button at the same time more
than 5 seconds to activate Lock
function.
04
Advertisement
