Display And Buttons; Display; Buttons - Carrier RG10B2BGEF Owner's Manual

2. DISPLAY AND BUTTONS

2.1 DISPLAY

Information are displayed when the remote controller is powered up.
Not applicable for this unit
Not applicable for this unit
Not applicable for this unit
Not applicable for this unit
Not applicable for this unit
Transmission Indicator
Lights up when remote
sends signal to indoor
unit
TIMER ON display
TIMER OFF display
Silence feature
display
FAN SPEED display
Displays selected fan speed:
LOW
MED
HIGH
AUTO
This fan speed can not be
adjusted in AUTO or DRY
mode.
Note:
All indicators shown in the figure are for the purpose of clear presentation. But during the actaul
operation, only the relative function signs are shown on the display window.
03
Not applicable for this unit
Not applicable for this unit
Sleep mode display
Follow me feature display
Wireless control feature display
(some units)
Low battery detection display(If flashes)
MODE display
Displays the current mode,
including:
ECO display
Displays when ECO
feature is activated
GEAR display
Not applicable for this unit
LOCK display
Displays when LOCK feature
is activated.
Temperature/Timer/Fan speed
display
Displays the set temperature
by default, or fan speed or
timer setting when using
TIMER ON/OFF functions.
Temperature range:
17-30 C/20-28 C o o
(Model dependent)
Timer setting range:
0-24 hours
This display is blank when
operating in FAN mode.

2.2 BUTTONS

Mode
Press the mode button to
switch the mode in turn.
NOTE: HEAT mode is not supported
by the cooling only appliance.
On/Off
Press to start operation.
Press again to stop.
Temperature UP
Increases temperature in
1 C increments.
Max. Temp. is 30 C .
SET
Scrolls through operation
functions as follows:
Fresh( ) Follow Me( )
 
AP mode( ) Fresh....

The selected symbol will flash on
the display area, press the OK
button to confirm.
OK
Used to confirm the selected
functions.
Fan Speed
Press to select the fan speed.
Turbo
Enables unit to reach preset
temperature in shortest possible time.
MODEL:RG10B2(U)/BGEF
RG10B10(U)/BGEF(20-28 C)
RG10B2(U)/BGCEF(
(
HEAT mode are not available
ECO Sleep
Press to enter Sleep Mode.
TIMER
Set timer to turn unit on or off.
Temperature Down
Decreases temperature in 1 C
increments. Min. Temp. is 17 C.
My Mode
Press to memorize or resume
your favorite pre-settings.
Swing
ECO
Starts and stops the horizontal louver
Sleep
movement. Hold down for 2 seconds
to initiate vertical louver auto swing
feature(some units).
Clean
Used to start/stop the Self Clean
or Active Clean function.
My
(Model dependent).
Mode
LED
Press to turn on/off the LED
display. Pressing 5 more
seconds to alternate the indoor
display between setting
temperature and room
temperature(Model dependent).
LOCK
Press together Clean button and
Turbo button at the same time more
than 5 seconds to activate Lock
function.
Cooling only models, AUTO mode and
)
04