Advertisement
4. HOW TO USE ADVANCED FUNCTIONS
Press this button 2 times during one second under HEAT Mode and setting temperature of 16 C/60 F.
F.P.
2
The unit will operate
at high fan speed (while
compressor on) with
temperature automatically
set to 8 C/46 F.
Note:This function is for heat pump air conditioner only.
Press this button 2 times under HEAT Mode and setting temperature of 16 C/60 F to activate the freeze
protection function. It will help to keep the room above 0 C/32 F (freezing point) in severe cold winter.
Press On/Off, Sleep, Mode, Fan and Temp. button while operating will cancel this function.
Keep pressing Fan button for more than 2 seconds to activate/disable Silence function.
2s
Silence
Due to low frequency operation of compressor, it may result in insufficient cooling and heating capacity.
Press ON/OFF, Mode, Sleep button, turn on F.P.or Self clean function while operating will cancel silence
function.(Model dependent)
Turbo
Humi d i t y
Press together
button and
5s
5s
Lock
Turbo
Humidity
Mode
At lock mode , all buttons will not response except pressing these two buttons for two seconds again to disable locking.
11
button at the same time more than 5 seconds to activate
Lock symbol displays
NOTES FOR USING REMOTE CONTROL
The device could comply with the local national regulations.
In Canada, it should comply with CAN ICES-3(B)/NMB-3(B).
In USA, this device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void
user's authority to operate the equipment.
12
Advertisement
