Measurement Settings - FLIR Extech VIR50 User Manual

Factory Default Setting
Use the ▲ and ▼ buttons to select either YES (revert to the factory default settings) or NO (cancel).
Press the ESC button to exit and save.

Measurement Settings

From the Video + IR, IR-only, or Dew Point modes, press the ENTER button to access the soft-key
screen. The Measurement Settings mode is represented by the middle icon. Use the arrow buttons
to scroll over to the middle icon (if it is not already highlighted.)
Press the ENTER button again when the middle icon is highlighted to access the Measurement
Settings mode as shown below.
Item
Emissivity set
Alarm High
Alarm Low
Laser
Auto Mode
MAX/MIN
AVG/DIF
Ambient TEMP/% RH
Dew-point/wet bulb
Type K
Description
Set the emissivity
Set the high alarm ON/OFF and set the alarm limit
Set the low alarm ON/OFF and set the alarm limit
Enable or disable the laser pointer
Lock the measurement ON
Display the highest (MAX) or lowest (MIN) IR temperature
Display Average temperature or Differential IR temperature
Display the air temperature and relative humidity
Display the dew-point and wet bulb temperature
Enable or disable the type-k contact thermocouple input
11
VIR50-EU-EN-V2.0 9/11