Turntable & Carriage Adjustment - Eagle 2000F Series Operation Manual

5.4 Turntable & Carriage Adjustment
Test Operation
Turntable
 Turn on the power
 From the Main Menu, press;
o ② Job Mode
o ② Manual Mode
o ⑤ Turntable (starts turntable rotation)
o ⑤ Turntable (stops turntable rotation)
 Verify there is no play in the turntable and that the fasteners are tight.
 The chain tension controls the amount of play in the turntable. The chain should have no more
than ±0.25" of play.
o If greater than ±0.25" of play, tighten the chain using the chain adjustment screw located at
the back of the frame.
Table Chain Adjustment
 Loosen the four holding screws of the turntable motor using a 6mm Allen Wrench.
 Turn the chain tension screw using an 8mm Allen Wrench.
o Clockwise adjustment will tighten the chain and counter-clockwise will loosen the chain.
 After adjusting to an appropriate position, tighten the turntable motor holding screws.
Carriage Chain Adjustment
 Press ⑨ Up to raise the carriage
 Press ③ Down to lower the carriage
 Look and listen for smooth and consistent operation. If the action is not smooth, check the carriage
chain for obstructions, wear, or damage.
Fig. 5-1
- 27 -