Troubleshooting Guide - Eagle 2000F Series Operation Manual

5.1 Troubleshooting Guide

Error Code
Machine will not function
Machine has power and
will not function
"Machine Pause"
Machine will not stop at
home
Machine will not start job
after reset
Screen displays Chinese
lettering
Possible Cause
Machine not plugged in.

Outlet where Machine is plugged

into has no power or bad outlet.
Power cord has been damaged.

Machine internal circuit breaker

tripped.
Input signal 05 is lit on PLC.

E-stop is pushed on main panel.

Carriage base safety switch pushed.

Film Feed Door is not closed

properly.
Drive display should display "rdy"

for them to be ready.
Input signal 03 is not lit on PLC.

Bad connection between mass and

turn table.
Bad Limit Switch/ Adjustment

Input 04 is not lit

Photoelectric Eye is not reading

package.
DB9 connector has come

unplugged or is loose.
DB9 connector is bad

Solution
















- 22 -
Plug machine into 110VAC
outlet.
Check to see if outlet has power.
Call service for new cord.
If machine breaker is tripped call
tech support.
Check all E-stop and debris
under carriage.
Adjustment may be needed to
carriage safety switch reference
4.2 carriage maintenance .
Close door with a firm push Do
Not slam or force.
If drive don't display "rdy" call
tech support
This Input will only illuminate
when the Limit Switch is on the
cam location.
Tighten or replace connector
ensure that their no pinched
wires.
Replace Limit Switch or adjust so
that rides on cam properly.
Photoelectric Eye is not sending
a signal to PLC.
Ensure that the both green and
amber are illuminated with load
in place.
Call tech support
Tighten connector on PLC and
Screen / Be sure to check power
connections as well
Replace DB9 Connector / call
tech support