Table of Contents
Advertisement
2.3 Installation
Step 1 - Place the machine in the desired location using a tow motor or crane capable of handling a
load of 3,000lbs.
(See Fig. 2-3)
Fig. 2-3
Step 2 - Remove the lower rear inspection panel on the mast prior to raising the mast. The panel is
located on the end of the machine next to the turntable motor
The panel has a warning label affixed
.
to it.
(See Fig. 2-4a & Fig. 2-4b)
Fig. 2-4a
Fig. 2-4b
Step 3 - Lift the mast using hoisting tools. A tow motor or hoist rated for at least 3,000lbs is required.
While lifting the mast, use caution to ensure that wires and connectors are not pinched.
(See Fig. 2-5a)
Once the machine is fully upright, one individual can stabilize the mast while a second individual
fastens the four M10 bolts to secure the mast to the base. The M10 bolts are to be tightened to
30ft/lbs of torque.
(See Fig. 2-5b)
Fig. 2-5a
Fig. 2-5b
- 9 -
Advertisement
Table of Contents
