Wireless Card; Removing The Wireless Card - Alienware Aurora R12 Service Manual

Steps
1. Ensure that the release lever on the processor socket is fully extended and the processor cover is fully open.
CAUTION: Position the processor correctly in the processor socket to avoid permanent damage to the processor.
2. Align the pin-1 corner on the processor with the pin-1 corner on the processor socket, and then place the processor in the
processor socket.
CAUTION: Ensure that the processor-cover notch is positioned underneath the alignment post.
3. When the processor is fully seated in the socket, close the processor cover.
4. Pivot the release lever down and place it under the tab on the processor cover.
Next steps
1. Install the processor liquid-cooling assembly
2. Install the left-side cover.
3. Follow the procedure in

Wireless card

Removing the wireless card

Prerequisites
1. Follow the procedure in
2. Remove the left-side cover.
3. Remove the single-graphics
About this task
The following images indicate the location of the wireless card and provides a visual representation of the removal procedure.
or processor fan and heat-sink
After working inside your
Before working inside your
card.
assembly, as applicable.
computer.
computer.
71