Overview; Precautions; Tools - Epson Stylus OFFICE B30 Service Manual

EPSON Stylus C110/C120/D120/WorkForce 30/EPSON Stylus OFFICE B30/T30/T33/ME OFFICE 70

4.1 Overview

This section describes procedures for disassembling the main components of the
product. Unless otherwise specified, disassembled units or components can be
reassembled by reversing the disassembly procedure. Procedures which, if not strictly
observed, could result in personal injury are described under the heading
"WARNING". "CAUTION" signals a precaution which, if ignored, could result in
damage to equipment. Important tips for procedures are described under the heading
"CHECK POINT". If the assembly procedure is different from the reversed
disassembly procedure, the correct procedure is described under the heading
"REASSEMBLY". Any adjustments required after reassembly of components or parts
are described under the heading "ADJUSTMENT REQUIRED". When you have to
remove any components or parts that are not described in this chapter, refer to the
exploded diagrams in the appendix.
Read the following precautions before disassembling and assembling.

4.1.1 Precautions

See the precautions given under the heading "WARNING" and "CAUTION" in the
following columns when disassembling or assembling EPSON Stylus C110/C120/
D120/WorkForce 30/EPSON Stylus OFFICE B30/T30/T33/ME OFFICE 70.
Disconnect the power cable before disassembling or assembling
W A R N I N G
the printer.
If you need to work on the printer with power applied, strictly
follow the instructions in this manual.
Always wear gloves for disassembly and reassembly to protect
your eyes from ink. If any ink gets in your eyes, wash your eyes
with clean water and consult a doctor immediately.
Always wear gloves for disassembly and reassembly to avoid
injury from sharp metal edges.
To protect sensitive microprocessors and circuitry, use static
discharge equipment, such as anti-static wrist straps, when
accessing internal components.
Never touch the ink or wasted ink with bare hands. If ink
comes into contact with your skin, wash it off with soap and
water immediately. If you have a skin irritation, consult a
doctor immediately.
DISASSEMBLY/ASSEMBLY
When transporting the printer after installing the ink
C A U T I O N
cartridge, pack the printer for transportation without
removing the ink cartridge and be sure to secure the Ink
Cartridge to the printer cover with tape tightly to keep it from
moving.
Use only recommended tools for disassembling, assembling or
adjusting the printer.
Observe the specified torque when tightening screws.
Apply lubricants as specified. See Chapter 6
Make the specified adjustments when you disassemble the
printer. (See Chapter 5
when reassembling the Waste Ink Tube, make sure that the tip
of waste ink tube is placed in the correct position, otherwise
ink may leak.
When using compressed air products; such as air duster, for
cleaning during repair and maintenance, the use of such
products containing flammable gas is prohibited.

4.1.2 Tools

Use only specified tools to avoid damaging the printer.
(+) Phillips screwdriver #1
(+) Phillips screwdriver #2
Flathead screwdriver
Flathead Precision screwdriver #1
Tweezers
Longnose pliers
Acetate tape
Nippers
Upper Case Opener
Note * :All of the tools listed above are commercially available.
EPSON provides the tools listed with EPSON tool code.
Overview
(p98) for details.)
Table 4-1. Tools
Name
EPSON Tool Code*
1080530
1003963
1108202
Revision C
(p107) for details.)
---
---
---
---
---
---
63
Confidential