Error Indications And Fault Occurrence Causes - Epson Stylus OFFICE B30 Service Manual

EPSON Stylus C110/C120/D120/WorkForce 30/EPSON Stylus OFFICE B30/T30/T33/ME OFFICE 70

3.2.2 Error Indications and Fault Occurrence Causes

This section describes the LED indications, STM3 messages and fault occurrence causes at occurrence of the following errors during any sequence/operation (e.g. power-on
sequence, paper feeding/loading sequence, ink sucking sequence).
Printer Status Communication Error
Power
Ink
Paper
Status monitor 3
message
This error occurs when the printer cannot
communicate with the PC correctly.
Fault
Occurrence
Cause
Table 3-11, "Check point for
Reference Page communication error according to each
phenomenon," on page 54
Note : "–" : No change
TROUBLESHOOTING
—
—
—
This error occurs when about 90 percent of
ink consumed.
Note :
Even if this error is indicated on the STM3,
you can continue printing until a "Replace Ink
Cartridge" error appears. However, the Head
Cleaning may not be performed during the ink
low status.
Ink Low
—
On
—
This error occurs when multiple sheets of
paper are fed simultaneously. The error
condition is detected when paper length
longer than its preset length is detected.
Table 3-10, "Check point for double feed
--- error according to each phenomenon," on
page 53
Troubleshooting
Double Feed
—
—
On
This error occurs when the PE sensor
failed to detect the top edge of a paper
during the paper feeding sequence.
Table 3-8, "Check point for paper out
error according to each phenomenon," on
page 50
Revision C
Paper Out
—
—
On
38
Confidential