Trina Solar TSM-DE21 User Manual

166-cell back sheet-glass framed module

Advertisement

Quick Links

USER MANUAL _166-cell Back Sheet-Glass Framed Module
USER MANUAL ................................................................................................................ 1
1.
INTRODUCTION FOR USER MANUAL ...................................................................... 2
1.1
DISCLAIMER ............................................................................................... 2
1.2
LIMITATION OF LIABILITY .......................................................................... 2
2.
SAFETY PRECAUTIONS ........................................................................................... 2
2.1
WARING ....................................................................................................... 2
2.2
GENERAL SAFETY ..................................................................................... 2
2.3
HANDLING SAFETY .................................................................................... 2
3.
UNLOAD/TRANSPROTATION/STORAGE ............................................................... 3
3.1
MAKERS ON OUTER PACKAGING ........................................................... 3
3.2
UNLOADING WARNNING ........................................................................... 4
3.3
SECONDARY TRANSPORT AND WARNNING ........................................ 5
3.4
STORAGE .................................................................................................... 6
4.
UNPACKING INTRODUCTION ................................................................................. 7
4.1
UNPACKING SAFETY ................................................................................. 7
4.2
UNPACKING STEP ..................................................................................... 7
5.
SITE SELECTION ...................................................................................................... 8
6.
TILT ANGLE ............................................................................................................... 9
7.
INSTALLATION ......................................................................................................... 9
7.1
INSTALLATION SAFETY ............................................................................. 9
7.2
INSTALLATION METHOD ......................................................................... 10
7.2.1 MECHINICAL INSTALLATION AND WARRING ....................................... 10
7.2.2 GROUNDING ............................................................................................. 15
7.2.3 ELECTRICAL INSTALLATION .................................................................. 17
8.
INVERTER SELECTION AND COMPATIBILITY .................................................... 19
9.
MODULE MAINTENANCE FOR PV MODULE PV .................................................. 19
9.1
PANEL VISION INSPECTION AND REPLACEMENT .............................. 19
9.2
CONNECTOR AND CABLE INSPECTION ................................................. 19
9.3
CLEANNING .............................................................................................. 20
9.3.1 REQUIREMENTS FOR WATER QUALITY .............................................. 20
9.3.2 MODULE INSPECTION AFTER CLEANING ............................................ 20
9.3.3 TROUBLESHOOTING 40 ........................................................................... 21
10. REPORTING TECHNICAL ISSUES or CLAIMS ..................................................... 21
Date: April 14, 2020
Doc No: PS-M-0871
Ver: B
Page 1 of 21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TSM-DE21 and is the answer not in the manual?

Questions and answers

Summary of Contents for Trina Solar TSM-DE21

  • Page 1: Table Of Contents

    USER MANUAL _166-cell Back Sheet-Glass Framed Module USER MANUAL ........................ 1 INTRODUCTION FOR USER MANUAL ..............2 DISCLAIMER ....................2 LIMITATION OF LIABILITY ................2 SAFETY PRECAUTIONS ................... 2 WARING ....................... 2 GENERAL SAFETY ..................2 HANDLING SAFETY ..................2 UNLOAD/TRANSPROTATION/STORAGE ...............
  • Page 2: Introduction For User Manual

    1.2 LIMITATION OF LIABILITY Trina Solar is not responsible for any form of damage, including but not limited to module operation and system installation error, and personnel injury, hurt, and property loss resulted from failure to follow the instructions in this Manual.
  • Page 3: Unload/Transprotation/Storage

    Do NOT use water to extinguish fires of an electrical origin. Do NOT install or handle modules when they are wet or during periods of high wind. At the installation site, take care to keep modules and in particular their electrical contacts, clean and dry before installation.
  • Page 4: Unloading Warnning

    3.1.5 3.1.6 Do NOT step on the package and module The carton can be recycled 3.1.7 3.1.8 Modules shall be stacked as required, not One module shall be handled by at least two exceeding the maximum number of layers persons together printed on the outer packaging.
  • Page 5: Secondary Transport And Warnning

    3.2.3 3.2.4 Store the module in a dry and ventilated place Do Not stack the modules at the project site. 3.2.5 Cover the module with waterproof material to prevent it from moisture SECONDARY TRANSPORT AND WARNNING 3.3.1 Do NOT remove the original packaging if 3.3.2 The finished package can be transported by land, the modules require long-distance transport or sea or air.
  • Page 6: Storage

    3.3.5 Only one layer stacking is only allowed 3.3.6 No transport or handling by pedi-cab as shown for transport at the project site below; 3.3.7 Do Not transport the module with rope as 3.3.8 Do Not carry the modules on the back of shown below: one person as shown below: STORAGE...
  • Page 7: Unpacking Introduction

    4. UNPACKING INTRODUCTION UNPACKING SAFETY : For unpacking outdoors, it is prohibited to operate in rainy conditions. Because the carton will become soft and damaged after it gets wet in the rain. The stacked PV modules (hereinafter referred to as "modules") may tip over, which may cause damage or injury to personnel. For a windy site, it is necessary to pay special attention to safety.
  • Page 8: Site Selection

    Position the modules to minimize the chances of shading at any time of the day. Trina Solar recommends that the module should be installed at a working ambient temperature of - 20℃~50℃. The module's limit working ambient temperature range is from -40℃ to 85℃. Maximum altitude less than or equal to 2000m .The maximum mechanical load is 5400 on the front and 2400...
  • Page 9: Tilt Angle

    The tilt angle measurement of the PV module refers to measuring the angle between the module and the horizontal ground surface. For different projects there are different mounting angles. Trina Solar recommends that the mounting tilt angle should be NOT less than 10° , or in accordance with local regulations or follow the recommendations of experienced PV module installers.
  • Page 10: Installation Method

    Installation holes of 4- φ9*14 mm are used for routine installation, as shown in Figure 1 , To maximize mounting longevity, Trina Solar strongly recommends the use of corrosion proof (stainless steel) attachment hardware.
  • Page 11 *NOTE: The actual load is + 5400Pa/-2400Pa B. Mounting with Clamps Trina Solar has tested its modules with a number of clamps from different manufacturers, mounting bolt of at least M8. The length of clamp ≥40mm (1.57in) , thickness≥ 3mm(0.12in).
  • Page 12 modules can bear the load. Applied torque should refer to mechanical design standard according to the bolt customer is using, ex: M8 ---- 16-20N.m(140-180lbf.in) End Clamp installation Middle Clamp installation Mechanica Safety Mounting Direction (The crossbeam is perpendicular to the long side Module l Load frame)
  • Page 13 4 installation holes of φ7*10 mm are used for Single-axis tracking system installation, as shown in Figure 2 To maximize mounting longevity, Trina Solar strongly recommends the use of corrosion proof (stainless steel) attachment hardware.
  • Page 14 Fig 2. Backsheet-Glass module with Single-axis Tracing System 1) M6 hex bolt M6 2) flat stainless washer 3) spring stainless washer 4) hex stainless nut Mechanical Load Module Safety factor Mounting Direction Pressure 144 pcs Back sheet- Glass Framed +1600 Pa /-1600 Pa Module *NOTE: The above-described distance is from the middle of the bolts to the middle...
  • Page 15: Grounding

     Trina Solar modules can be installed with the use of third party listed grounding devices for grounding the metallic frames of PV modules. The devices have to be installed in accordance with the grounding device manufacturer’s specified instructions.
  • Page 16 washer and wire  Electrical contact is made by penetrating the anodized coating of the aluminum frame, and tightening the mounting screw (come with the star washer) to the proper torque of 25lbf.in.  Grounding wire size (6 to 12 AWG solid bare copper) should be selected and installed underneath the wire binding bolt.
  • Page 17: Electrical Installation

    Trina Solar modules are provided with stranded copper cables with a cross sectional area of 4mm² (0.006in² ) which are UV resistant. All other cables used to connect the DC system should have a similar (or better) specification.
  • Page 18 The number of modules in series and in parallel shall be designed reasonably according to the system configuration. All instructions above have to be obeyed to maintain Trina Solar’s limited warranty. Connecting in series Connecting in parallel after connected in series...
  • Page 19: Inverter Selection And Compatibility

    Cover the front surface of modules by an opaque material when repairing. Modules when exposed to sunlight generate high voltage and are dangerous. Trina Solar PV modules are equipped with bypass diodes in the junction box. This minimizes module heating and current losses.
  • Page 20: Cleanning

    least once a year. Also, check that mounting hardware is properly torqued. Loose connections will result in damage to the array. 9.3 CLEANING The amount of electricity generated by a solar module is proportional to the amount of light falling on it. A module with shaded cells will produce less energy and therefore it is important to keep all PV modules clean.
  • Page 21: Troubleshooting 40

    10. REPORTING TECHNICAL ISSUES or CLAIMS  Contact your installer  Contact Trina Solar after sales service team at http://customerservice.trinasolar.com/  Submit the Customer Feedback form at: http://www.trinasolar.com/ and one of our technical service representatives will contact you within 5 business days.

Table of Contents