Table of Contents
Advertisement
Remote Controller
Remote Controller Profile
DJI Mini 2 comes equipped with the DJI RC-N1 remote controller, which boasts DJI's long-range OcuSync
2.0 transmission technology, offering a maximum transmission range of 6 mi (10 km) and 720p when
displaying video from the aircraft to DJI Fly on your mobile device. Easily control the aircraft and camera
using the onboard buttons. The detachable control sticks make the remote controller easier to store.
In a wide-open area with no electromagnetic interference, OcuSync 2.0 smoothly transmits video links
at up to 720p. The remote controller works at both 2.4 GHz and 5.8 GHz, and will automatically select
the best transmission channel.
OcuSync 2.0 reduces latency to approx. 200 ms by improving the camera performance through the
video decoding algorithm and the wireless link.
The built-in battery has a capacity of 5200 mAh and a maximum run time of 6 hours. The remote
controller charges the mobile device with a charging ability of 500mA@5V. The remote controller
automatically charges Android devices. For iOS devices, first make sure that charging is enabled in
DJI Fly. Charging for iOS devices is disabled by default and needs to be enabled each time the remote
controller is powered on.
Compliance Version: The remote controller is compliant with local regulations.
Control Stick Mode: The control stick mode determines the function of each control stick movement.
Three pre-programmed modes (Mode 1, Mode 2, and Mode 3) are available and custom modes can
be configured in DJI Fly. The default mode is Mode 2.
Using the Remote Controller
Powering On/Off
Press the power button once to check the current battery level. If the battery level is too low, recharge
before use.
Press once, then press again and hold to power the remote controller on or off.
Charging the Battery
Use a USB-C cable to connect the USB charger to the USB-C port of the remote controller. It takes
approx. four hours to fully charge the remote controller.
Controlling the Gimbal and Camera
1. Shutter/Record Button: press once to take a photo or to start or stop recording.
2. Photo/Video Toggle: press once to switch between photo and video mode.
©
28
2021 DJI All Rights Reserved.
Advertisement
Table of Contents
