Advertisement
PARTS REQUIRED:
Temporary Spacer
x1
3/8 x 1-3/4 x 71-1/2" (1 x 4,4 x 181,6 cm)
Temporary Support
x1
DBA
2 x 4 x 72-3/8" (5,1 x 10,2 x 182,9 cm) PVC
BEGIN
Hold DBA in place, centered over door opening and flush along the upper edge of top plate.
1
Pre-drill four evenly spaced 7/16" screw holes through DBA into header.
Mark center of door opening on top plate - this mark will be used later.
Do not install DBA at this time. DBA will be used to support the doors during installation,
and will be installed after doors are installed. You will use the same pre-drilled holes.
2
Temporarily install DBA at 3/8" below bottom of wall panels (Fig. A).
Use (1) 3/8 x 1-3/4 x 71-1/2" trim as a 3/8" spacer between the wall panels ad DBA.
Secure DBA to floor frame with (4) 3" deck screws, using the four pre-drilled holes.
Remove the 3/8" spacer after DBA is secure.
DOOR INSTALLATION
CENTER
DBA
Flush
Temporary
Spacer
DBA
3" (7,6 cm) Deck Screws
DBA
x4
7/16" BIT
(11 mm)
7/16" (11 mm)
Pre-drilled holes
T O P
P L A T E
Mark center
3/8" (1,0 cm)
3" (7,6 cm)
Screws
46
3" (7,6 cm)
CENTER
H E A D E R
Flush
Fig. A
7/16" (11 mm)
Pre-drilled holes
Temporary
Spacer
Advertisement
