Grounding The Access Point - Cisco Catalyst IW9165E Quick Start Manual

Installation Overview
To remove the router from the DIN Rail, simply reverse the procedure.
Note

Grounding the Access Point

In all installations, after mounting the access point, you must properly ground the unit before connecting
power cables.
Warning
Warning
The access point is shipped with a grounding kit.
Figure 9: Access Point Grounding Kit Contents
1
Note
To ground the access point:
Step 1 Use a crimping tool to crimp a 6-AWG ground wire (not included in the grounding kit) to the ground lug.
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Grounding lug
The grounding kit also includes the oxide inhibitor, which is contained in a tube.
Grounding the Access Point
2 6-32 screws x 2
Installation Overview
9