Table of Contents
Advertisement
Add or Remove Devices
After gateways are set up, use the Devices section
to add or remove Graco devices.
1. Click Devices >> Add.
a. Gateway drop down: Choose a gateway
through which the AWI will communicate
with Graco devices. For example, if you are
adding a ProMix, select TCP Local. If you
are adding an Informer or a ProControl 1KE,
select Modbus TCP Local.
b. Device name: Type the name of your
choosing in the field, for example, Informer2.
c. Device address, ProMix: Type in the IP
address that you set up on the EasyKey.
d. Device address, Informer or ProControl 1KE:
Type in the modbus addresses (1–247) that
you set up.
332459A
2. Click Add.
Get other manuals https://www.bkmanuals.com
System Configuration
a. Successful Add: A check mark appears
(briefly) in the upper right hand corner of the
screen. Then, the Network Tab appears with
the new device listed.
b. Unsuccessful Add: An exclamation point
appears in the upper right hand corner of the
screen. Click Cancel. On the Network Tab
select Gateways >> Remove. Double check
that your gateway address is correct. If it is
not correct, click Remove. Add the gateway
again, with the correct address. Then try
adding your device again.
21
Advertisement
Table of Contents
