Graco 15V337 Instructions-Parts List Manual page 15

Network
Local Network Configuration
In a local network mode, the AWI module is
configured for a closed network that includes a PC
and Graco devices. In this mode, AWI is set to a
static IP address (192.168.178.200). The system
enables DHCP and DNS servers.
1. On the Settings Tab, in the Network section,
select Local network.
2. Click Save, and when the confirmation screen
appears, click Confirm.
NOTE: Be sure there is no physical connection
to another existing LAN in local network mode. It
will lead to a possible disturbance to the network
operation.
Manual Configuration
In manual configuration mode, the AWI module
can be configured to operate on an existing local
area network (LAN). In this mode, the AWI is
assigned to a static IP address, gateway, and
netmask chosen by the user. The system will
disable DCHP and DNS servers. In addition, a
virtual network interface will be enabled (IP aliasing,
192.168.178.200/255.255.255.0).
332459A
1. To change to a manual network configuration,
2. On the Settings Tab, in the Network section,
3. Enter the IP address, gateway and netmask.
4. Click Save.When the confirmation page appears,
Once the new settings are confirmed, the AWI will
disconnect the user computer. Reconnect the AWI
and computer. Reconfigure the user computer to
match the new LAN configuration. You can then login
to the AWI using the newly assigned IP address.
NOTE: If you change the addresses in this section,
be certain that the new adresses will work and be
sure to write them down. These addresses provide
access to the AWI program. If you change these
addresses and cannot remember the new ones, you
will not be able to access any AWI screens.
Get other manuals https://www.bkmanuals.com
System Configuration
connect and configure the AWI in local
network mode. See Connections, page 6
Computer Configuration, page 8
select Manual configuration.
Contact your IS system administrator for
assistance.
NOTE: Make sure there is no other device on the
network with a conflicting IP configuration.
click Confirm.
and
.
15