Table of Contents
Advertisement
System Configuration
Add or Remove Gateways
The AWI module communicates with Graco devices
through gateways installed in the system. The AWI
Module comes with default gateways set. Use the
Gateways section to add additional gateways through
which the AWI will communicate with Graco devices.
Add gateways before adding additional devices.
1. Click Gateways >> Remove. The popup window
shows the gateways that already are installed.
TCP Local is the default gateway installed for
ProMix users. Modbus TCP Local is the default
gateway installed for Informer/ProControl IKE
users.
NOTE: To use the AWI Module,
Informer/ProControl 1KE users must have
purchased and installed Communication Kits
24N977 and 24N978. See Graco Manual 332356
for further information.
NOTE: Do not remove these default gateways. If
they are removed accidentally, see Step 2d for
information on how to restore them.
20
2. To add a gateway, click Gateway >> Add. Add a
gateway if you accidentally removed the default
gateway, or to extend your network by adding
additional Modbus Gateway kits.
a. Gateway Type, ProMix: In the drop down
b. Gateway Type, Informer/ProControl 1KE: In
c. In the Name field, type an identifying name
d. In the Address field, type the IP address of
Get other manuals https://www.bkmanuals.com
menu, select tcp_local.
the drop down menu, select modbus_tcp_rtu.
of your choosing, for example Factory1, or
Line3.
the gateway, established when you installed
that particular gateway.
NOTE: if you are restoring the default
gateway, the IP address is 192.168.178.205.
http://.
Be sure to eliminate
address only.
Use the IP
332459A
Advertisement
Table of Contents
