Table of Contents
Advertisement
System Configuration
Recover IP Settings
If you have lost your IP settings and can no longer
access screens, you can force a network reset to
configure the AWI to the default Local Network
Configuration.
NOTICE
To avoid damage to the circuit board, wear Part No.
112190 grounding strap, and ground appropriately.
1. Turn off power to the AWI unit.
2. On the AWI computer board (TS-7800), remove
the jumper from JP1. Put it on DIO pin pair 1
(noted by dot).
JP-1
NOTICE
Be certain you move the jumper only to DIO
pin pair 1. Other placement of the jumper will
damage the board.
16
3. Power up the AWI and wait one minute, then
4. Remove the jumper from DIO 1. Put it back on
5. Power up the unit. The system will operate in
6. The Login screen appears. Log in with the login
DIO-1
ti21708a
Get other manuals https://www.bkmanuals.com
power it down again.
JP1.
default Local Network Configuration. To login,
type http://gracoawi or http://192.168.178.200 in
the browser address bar. Press Enter.
and password you set up. Your settings will be
intact.
332459A
Advertisement
Table of Contents
