Intended use Cleaning and maintenance . . . 24 Intended use Overall condition of the machine . . . 24 I n t e n d e d u s e Special salt and rinse aid ..24 This appliance is intended for Filters .
Safety instructions Keep children below the age of Installation 8 years old at a safe distance Following installation, ensure from the appliance and power that the back cable. of the dishwasher is not freely accessible (protection Before you switch ON the against contact due to hot appliance surface).
Safety instructions If the dishwasher is installed Do not install the appliance below or above other near heat sources (radiators, domestic appliances, follow heat storage tanks, cookers the information for installation or other appliances which in combination with generate heat) and do not a dishwasher install under a hob.
Safety instructions Childproof lock (door lock) Warning D o o r l o c k Risk of injury! The description of the childproof lock is at the back in To prevent injuries, e.g. the envelope. caused by stumbling, open the dishwasher only briefly * depending on model in order to load and unload the dishwasher.
Page 8
Safety instructions Ensure that children do not Warning place fingers in the tablet Risk of scalding! collecting tray 12. Small Open the door carefully when fingers could become the programme is still running. caught in the slots. There is a risk of hot water When opening and closing spraying out of the appliance.
Protection of the environment Protection of the Getting to know your environment appliance i o n P r o t e c t o f t e n v i r o n m e n t G e t t i t o k n o w y o u r a p p l i a n c...
Water softening system/Special salt Appliance interior Setting The amount of salt dispensed can be 1" Top basket set from : to : 1* Knife shelf * Salt is not required at the set 12 Tablet collecting tray value : 1: Top spray arm 1.
Water softening system/Special salt As soon as the salt refill indicator h Water hardness table on the fascia is lit, top up the salt. * depending on model Using detergents with salt component D e t e r g e n t s w i t h s a l t c o m p o n e n t If combined detergents with a salt Using special salt component are used, salt can usually be...
Rinse aid 3. Close cover until it clicks shut. Rinse aid 4. To prevent excessive foam formation R i n s e a i d during the next rinse cycle, remove any rinse aid which has run over with As soon as the rinse-aid refill indicator ` is lit on the fascia, there a cloth.
Utensils Loading the dishwasher Utensils U t e n s i 1. Remove large food remnants. It is not necessary to prerinse utensils Not suitable under running water. 2. Place the utensils so that Cutlery and utensils made of wood. –...
Utensils Cups and glasses Pans Top basket 1" Bottom basket 1b Note Utensils must not be placed above the Heavily soiled utensils (pans) should tablet collecting tray 12. These may be placed in the bottom basket. The block the lid of the detergent dispenser more powerful spray jet provides and prevent it from opening fully.
Utensils Cutlery basket F olding spikes * F o l d i n g s p i k e s You should always place cutlery * depending on model unsorted with the points downwards. The spikes can be folded down to To prevent injuries, place long, pointed improve arrangement of pans, bowls implements and knives on the knife...
Utensils Knife shelf * Top basket with side levers K n i f e s h e l f 1. Pull out the top basket 1" out. * depending on model 2. To lower the basket, press in the left Long knives and other utensils can be and then the right lever on the arranged horizontally.
Detergent Adding detergent Detergent 1. If the detergent dispenser 9" is still D e t e r g e closed, press the lock 9* to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing up liquid.
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets can be purchased online may not have full cleaning effect...
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options § Half load * H a l f l o a d If you have only a few items to wash Programme selection (e.g. glasses, cups, plates), you can switch to “half load”. This will save You can select a suitable programme water, energy and time.
Operating the appliance Switching on the appliance Operating the appliance 1. Turn on the tap fully. 2. Switch on ON/OFF switch (. O p e r a t i i a n c e t h e a p p l 3.
Operating the appliance T imer programming * Automatic disconnection T i m e r p r o g r a m m i n g can be adjusted from : to : * depending on model Appliance does not switch off automatically You can delay the start of the Off after 1 min...
Operating the appliance Interrupting the programme Intensive drying 1. Switch off ON/OFF switch (. The final rinse uses a higher temperature which improves the drying The LEDs go out. The programme is result. The running time may increase saved. slightly. (Caution if utensils are delicate!) If the door was opened on an appliance which has a warm water 1.
Cleaning and maintenance Never use a steam cleaner to clean your Cleaning and dishwasher. The manufacturer is not liable for any consequential damage. maintenance Regularly wipe the front of the appliance C l e a n i a n d n a n c e m a i n t e and fascia with a damp cloth;...
Cleaning and maintenance Filters Spray arms The filters 1R keep large foreign Limescale and contaminants in the objects in the rinsing water away from rinsing water may block nozzles and bearings on the spray arms 1: and the pump. These foreign objects may occasionally block the filters.
Fault, what to do? In this case: Fault, what to do? 1. First always disconnect F a u l t , w h a t d o ? the appliance from the power supply. Experience has shown that you can 2.
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display )" lights up. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min.
Page 28
Fault, what to do? Fault Cause Remedial action Error code : is lit. Waste water pump blocked Clean pump and lock cover correctly. (See or cover on the waste water Waste water pump) pump is not locked in position. Error code : is lit.
Page 29
Fault, what to do? Fault Cause Remedial action Utensils not dry. No or too little rinse aid Refill rinse aid. in the dispenser. Programme selected without Select programme with drying (see drying. Overview of programmes, Programme sequence). Water collecting in depressions Arrange utensils in a sloping position, on the utensils and cutlery.
Page 30
Fault, what to do? Fault Cause Remedial action Food remnants Utensils placed too closely Arrange utensils with adequate clearance on the utensils. together, utensils basket between them ensuring that the spray jets overfilled. can reach the surface of the utensils. Prevent contact points.
Page 31
Fault, what to do? Fault Cause Remedial action Water stains on plastic Droplet formation on plastic Use a more intensive programme (more parts surface is physically unavoidable. water changes). After drying, water stains are Arrange utensils in a sloping position. visible.
Page 32
Fault, what to do? Fault Cause Remedial action Coloured (blue, yellow, Film formation consisting Can be partly removed with machine brown), difficult to remove of ingredients from vegetables cleaner or by mechanical cleaning. Coatings to non-removable coatings (e.g. cabbage, celery, potatoes, are harmless.
Page 33
Fault, what to do? Fault Cause Remedial action Initial or existing, Glasses not dishwasher-proof, Use dishwasher-proof glasses. irreversible clouding only suitable for dishwasher. Avoid long steam phase (standing time after of glass. wash cycle ends). Use wash cycle at lower temperature. Set water softening system according to the water hardness (if required one setting lower).
Page 34
Fault, what to do? Fault Cause Remedial action Detergent residue Spray arms blocked by utensils, Ensure that the spray arms can rotate freely. in the detergent dispenser therefore detergent is not rinsed or in the tablet collecting out. tray. The detergent dispenser was Pour detergent into the dry detergent damp when filled.
Customer service Customer service Installation and connection C u s t o m e r s e r v i c e If you are unable to rectify the fault, l a t i o n I n s t a l a n d c o n n e c t i please contact your customer service.
Installation and connection Delivery Installation Your dishwasher has been checked The required installation dimensions can thoroughly in the factory to ensure that it be found in the installation instructions. is in working order. This may cause Level the appliance with the aid of the small water stains.
Installation and connection Drinking water connection Warm water connection W a r m w a t e r c o n n e c t i o n 1. Fasten the drinking water connection * depending on model to the tap according The dishwasher can be connected to the installation instructions using to cold or hot water up to max.
Installation and connection Electrical connection 4. Loosen fastening screws for the furniture parts. 5. If fitted, remove the base panel. Connect the appliance to an alternating current only, ranging from 6. Pull out the appliance, carefully 220 V to 240 V and 50 Hz or 60 Hz pulling the hose behind.
Need help?
Do you have a question about the JS05IN50 and is the answer not in the manual?
Questions and answers