Intended use Cleaning and maintenance . . . 23 Intended use Overall condition of the machine . . . 23 I n t e n d e d u s e Special salt and rinse aid ..24 This appliance is intended for Filters .
Safety instructions Keep children below the age of Installation 8 years old at a safe distance Following installation, ensure from the appliance and power that the back cable. of the dishwasher is not freely accessible (protection Before you switch ON the against contact due to hot appliance surface).
Safety instructions If the dishwasher is installed Do not install the appliance below or above other near heat sources (radiators, domestic appliances, follow heat storage tanks, cookers the information for installation or other appliances which in combination with generate heat) and do not a dishwasher install under a hob.
Safety instructions Childproof lock (door lock) Warning D o o r l o c k Risk of injury! The description of the childproof lock is at the back in To prevent injuries, e.g. the envelope. caused by stumbling, open the dishwasher only briefly * depending on model in order to load and unload the dishwasher.
Page 8
Safety instructions Ensure that children do not Warning place fingers in the tablet Risk of scalding! collecting tray 12. Small Open the door carefully when fingers could become the programme is still running. caught in the slots. There is a risk of hot water When opening and closing spraying out of the appliance.
Protection of the environment Protection of the Getting to know your environment appliance i o n P r o t e c t o f t e n v i r o n m e n t G e t t i t o k n o w y o u r a p p l i a n c...
Water softening system/Special salt Appliance interior Setting The amount of salt dispensed can be 1" Top basket set in 4 stages 1* Knife shelf * depending on the hardness of your 12 Tablet collecting tray water. Accordingly 0, 1, 2 or 3 displays are lit (see table).
Water softening system/Special salt Water hardness table Using special salt Using detergents with salt component D e t e r g e n t s w i t h s a l t c o m p o n e n t Always refill with special salt immediately before switching on the If combined detergents with a salt...
Rinse aid 3. Close cover until it clicks shut. Rinse aid 4. To prevent excessive foam formation R i n s e a i d during the next rinse cycle, remove any rinse aid which has run over with As soon as the rinse-aid refill indicator )"...
Utensils Switching off rinse-aid refill Glass and utensil damage indicator Causes: If the rinse-aid refill indicator )" is Glass type and glass production impaired (e.g. when using combined process. detergents containing rinse-aid Chemical composition of the component), it can be switched off. detergent.
Utensils Unloading the dishwasher Note Utensils must not be placed above the tablet collecting tray 12. These may To prevent water from dripping off the upper basket onto the utensils in the block the lid of the detergent dispenser lower basket, it is recommended and prevent it from opening fully.
Utensils * Depending on the model, a 3-fold height adjustment is possible. To do Other examples, such as the best way this, first place the etagere vertically of loading your dishwasher, can and pull up, then place at a slight angle, be found on our homepage as a free push down to the required height (1, 2, download.
Utensils Knife shelf * Top basket with side levers K n i f e s h e l f 1. Pull out the top basket 1" out. * depending on model 2. To lower the basket, press in the left Long knives and other utensils can be and then the right lever on the arranged horizontally.
Detergent Adding detergent Detergent 1. If the detergent dispenser 9" is still D e t e r g e closed, press the lock 9* to open You can use tablets as well as powder the detergent dispenser. or liquid detergents for dishwashers, but never use washing up liquid.
Detergent Notes If the utensils are only lightly soiled, You will obtain optimum rinsing slightly less than the indicated amount and drying results by using solo of detergent is usually adequate. detergents and applying salt and rinse aid separately. Suitable detergents and care products If programmes are short, tablets can be purchased online may not have full cleaning effect...
Overview of programmes Overview of programmes p r o g r a m m e s O v e r v i e w o f The max. possible number of programmes is illustrated in this overview. The corresponding programmes and their arrangement can be found on the fascia.
Additional options Ï Intensive zone * I n t e n s i v e z o n e Perfect for a mixed load. You can wash Programme selection very soiled pots and pans in the lower basket together with normally soiled You can select a suitable programme utensils in the upper basket.
Operating the appliance 4. Press the START button h. Operating 5. Close the door. the appliance The programme starts running. O p e r a t i i a n c e t h e a p p l Note Programme data - for environmentally friendly operation of the dishwasher:...
Operating the appliance T imer programming * To change the setting: T i m e r p r o g r a m m i n g 1. Press the button < H until the required setting has been * depending on model selected.
Cleaning and maintenance Changing the programme Cleaning and maintenance When the START button h has been pressed, the programme cannot be C l e a n i a n d m a i n t e n a n c e changed.
Cleaning and maintenance Never use a steam cleaner to clean your Filters dishwasher. The manufacturer is not liable for any consequential damage. The filters 1R keep large foreign Regularly wipe the front of the appliance objects in the rinsing water away from and fascia with a damp cloth;...
Fault, what to do? Spray arms Fault, what to do? F a u l t , w h a t d o ? Limescale and contaminants in the rinsing water may block nozzles and Experience has shown that you can bearings on the spray arms 1: and rectify most faults which occur in daily operation yourself.
Fault, what to do? Waste water pump 6. Check impeller wheel and remove any foreign objects. 7. Place cover in the original position Large food remnants or foreign objects and press down until it engages which were not captured by the filters (click).
Fault, what to do? Fault table Fault Cause Remedial action “Check water supply” Supply hose kinked. Install supply hose without kinks. display )2 lights up. Tap turned off. Turn the tap on. Tap jammed or calcified. Turn the tap on. Flow rate must be min.
Page 28
Fault, what to do? Fault Cause Remedial action Displays flash. Door not closed properly. Close the door. Ensure that no objects (utensil, fragrance dispenser) are protruding over the basket and preventing the door from closing. Refill indicator for salt )* No rinse aid.
Page 29
Fault, what to do? Fault Cause Remedial action Cutlery not dry. Cutlery not arranged properly in Separate cutlery if possible, prevent contact the cutlery basket. points. Cutlery not arranged properly in Arrange cutlery properly and separate if the cutlery drawer. possible.
Page 30
Fault, what to do? Fault Cause Remedial action Detergent residue. Detergent dispenser cover Detergent dispenser cover must not be blocked by utensils and therefore obstructed by utensils. does not open fully. Do not place utensils or fragrance dispenser in the tablet collecting tray. Detergent dispenser cover Tablet must be inserted flat and not upright.
Page 31
Fault, what to do? Fault Cause Remedial action White, stubborn coatings; Detergent substances are Change detergent brand. limescale on the utensils, deposited. These coatings cannot Clean appliance mechanically. container or door. usually be removed with chemicals (appliance cleaner, ...). Hardness range incorrectly set or Set water softening system according to water hardness greater than 8.9 instructions for use or top up salt.
Page 32
Fault, what to do? Fault Cause Remedial action Plastic parts discoloured. Too low rinsing temperature. Select programme with higher washing temperature. Utensils precleaned too intensely; Do not prerinse utensils. Remove only large sensors therefore decide on food remnants. weak programme sequence. Recommended programme Eco 50°...
Page 33
Fault, what to do? Fault Cause Remedial action Appliance does not start. The mains fuse has tripped. Check mains fuse. Power cord not inserted. Ensure that the power cord is plugged all the way into the back of the appliance and into the socket.
Customer service Fault Cause Remedial action Unusual foam formation. Handwash liquid in the rinse aid Immediately refill rinse aid dispenser with dispenser. rinse aid. Rinse aid spilled. Remove rinse aid with a cloth. Customer service C u s t o m e r s e r v i c e If you are unable to rectify the fault, Rely on the competence of the manufa...
Installation and connection Delivery Installation and connection Your dishwasher has been checked thoroughly in the factory to ensure that it l a t i o n I n s t a l a n d c o n n e c t i is in working order.
Installation and connection Installation Drinking water connection The required installation dimensions can 1. Fasten the drinking water connection be found in the installation instructions. to the tap according Level the appliance with the aid of the to the installation instructions using height-adjustable feet.
Installation and connection Electrical connection Removing the appliance Connect the appliance to an Also observe alternating current only, ranging from the sequence of worksteps here. 220 V to 240 V and 50 Hz or 60 Hz 1. Disconnect the appliance from via a correctly installed socket with the power supply.
Installation and connection Transportation Protection against frost P r o t e c t i o n a g a i n s t f r o s t ( E m p t y i n g t h e a p p l i a n c e ) Empty the dishwasher and secure loose If the appliance is in a room where there parts.
Need help?
Do you have a question about the JS05VN90 and is the answer not in the manual?
Questions and answers