Table of Contents
Advertisement
SECTION 6. CARE OF YOUR MACHINE
Adjusting Stretch Stitch Balance
The sewing results of the stretch stitch patterns may
vary depending upon the sewing conditions, such as
sewing speed, type of the fabric, number of layers, etc.
Always test sew on a scrap piece of the fabric that
you will be using.
q Stretch stitch balancing dial
w Standard setting mark
e Groove
Example: (Stitch pattern
(A)If the pattern is compressed, turn the stretch stitch
balancing dial in the direction of "+".
(C)If the pattern is drawn out, turn the stretch stitch
balancing dial in the direction of "–".
NOTE:
In normal sewing, set the dial to the neutral position,
i.e. the groove on the dial is centered with the
standard setting mark.
Replacing the Light Bulb
WARNINGS:
Turn OFF the power before replacing the light bulb.
The bulb could be HOT, wait until it has cooled
down before touching it.
Open face plate cover.
Pull out the light bulb.
q Face cover plate
w Lamp socket
e light bulb
To insert the light bulb in the lamp socket, match the
base on the light bulb with the lamp socket holes.
Close face plate cover.
NOTE:
Replace the bulb with the same type rated 12V, 5W.
Always refer to the part number #000026002 when
ordering a replacement bulb.
)
q
(A)
q
w
78
w
e
(B)
(C)
e
Advertisement
Table of Contents
