Table of Contents
Advertisement
en Disposal
Fault
The time is not dis-
played when the ap-
pliance is switched
off.
Appliance door can-
not be opened.
Home Connect is not
working properly.
During simple mi-
crowave operation,
the cooking compart-
ment becomes hot.
The interior lighting
does not work.
Maximum operating
time reached.
Error code made up
of letters and num-
bers appears on the
display, e.g. E0111.
The cooking result is
not satisfactory.
26 Disposal
26.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
34
Cause and troubleshooting
Basic setting has been changed.
▶
Change the basic setting for the time display.
→ "Basic settings", Page 23
The cleaning function locks the appliance door;
▶
Allow the appliance to cool down until goes out in the display.
→ "Cleaning function Pyrolytic activeClean", Page 28
The childproof lock locks the appliance door.
▶
Use the
button to deactivate the childproof lock.
→ "Childproof lock", Page 23
You can switch off the lock in the basic settings.
→ "Basic settings", Page 23
Different causes are possible.
▶
Go to www.home-connect.com.
The drying function is switched on.
To prevent condensation from forming when the appliance is in microwave-only mode, the
appliance automatically switches on an additional heating element when it is set to 600 W
or 800 W. The cooking result is not affected by this.
▶
You can change the basic setting for the drying function during microwave operation.
→ "Basic settings", Page 23
Observe the information on operating with microwave.
‒
→ "Microwave", Page 17
The LED light is defective.
▶
Call the after-sales service.
→ "Customer Service", Page 35
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
1.
To continue operation, switch the appliance off and on again using
the operation.
2.
If you do not need to use the appliance, press
Tip: To prevent the appliance from switching off when you do not want it to, set a cooking
time.
→ "Time-setting options", Page 16
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→ "Customer Service", Page 35
Settings were unsuitable.
Adjustment values, e.g. temperature or cooking time, depend on the recipe, quantity and
food.
▶
Next time, set lower or higher values.
Tip: A lot of other information about the food preparation and corresponding adjustment
values can be found in the Home Connect app or on our website siemens-home.bsh-
group.com .
lights up in the display.
to switch it off.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
. Reset and start
Advertisement
Table of Contents
