Zanussi ZOB22601BK User Manual page 14

Stainless steel or aluminium appliances
Clean the oven door with a damp
cloth or sponge only. Dry it with a
soft cloth.
Do not use steel wool, acids or
abrasive materials as they can
damage the oven surface. Clean the
oven control panel with the same
precautions.
Cleaning the door gasket
• Regularly do a check of the door gasket. The
door gasket is around the frame of the oven
cavity. Do not use the appliance if the door
gasket is damaged. Contact an Authorised
Service Centre.
• To clean the door gasket, refer to the
general information about cleaning.
Removing the shelf supports
To clean the oven, remove the shelf supports.
1. Pull the front of the shelf support away from
the side wall.
2. Pull the rear end of the shelf support away
from the side wall and remove it.
1
Install the shelf supports in the opposite
sequence.
Aqua Cleaning
The Aqua cleaning procedure uses steam to
help remove remaining fat and food particles
from the oven.
14
2
1. Put 300 ml of water into the Aqua cleaning
container at the bottom of the oven.
2. Set the function
3. Set the temperature to 90 °C.
4. Let the appliance operate for 30 minutes.
5. Deactivate the appliance and let it cool
down.
6. When the appliance is cool, clean the
inside of the oven with a soft cloth.
WARNING!
Make sure that the appliance is
cool before you touch it. There is
a risk of burns.
Cleaning the oven door
The oven door has two glass panels. You can
remove the oven door and the internal glass
panel to clean it.
The oven door can close if you try to
remove the internal glass panel
before you remove the oven door.
CAUTION!
Do not use the appliance without the
internal glass panel.
Open the door fully
1
and hold the two
door hinges.
Close the oven door
3
halfway to the first
opening position.
Then pull forward and
remove the door from
its seat.
.
Lift and turn the
2
levers on the two
hinges.
Put the door on a soft
4
cloth on a stable
surface.
www.zanussi.com