Connecting the
Projector
When you connect the projector,
make sure to:
• Turn off all equipment before making any
connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose
connections may increase noise and
reduce performance of picture signals.
When pulling out a cable, be sure to pull it
out by the plug, not the cable itself.
When connecting to a LAN using a LAN
cable, see "Operating Instructions for
Network" stored on the CD-ROM.
To remove the connector covers
Before connection, remove the connector
covers on both sides of the lens.
First remove the two screws on the bottom of
each connector cover, and then lift up the
bottom side of the cover as in the illustration.
The connector covers are connected with the
main unit by the fall-prevention wires.
INPUT
SHIFT
ZOOM
FOCUS
MENU
ENTER
Fall-prevention
wire
Connecting a Computer
This section describes how to connect the
projector to a computer.
For more information, refer to the
computer's instruction manual.
Connecting the Projector
INPUT A
RGB
INPUT D
HDMI
INPUT B
RGB
OUTPUT
MONITOR
R/R-Y/P
R
G/Y
B/B-Y/P
B
SYNC/HD
VD
INPUT C
INPUT E
21