Features - Sony HDMI VPL-FH300L Operating Instructions Manual

Features

High brightness · High picture
performance
High brightness
Sony's unique optical system with the new-
generation LCD panel "BrightEra"
incorporating a newly developed inorganic
alignment allows a light output of 6000
lumen in VPL-FH300L and 7000 lumen in
VPL-FW300L.
High resolution
VPL-FH300L: Three 2K × 1K panels with
2,210,000 pixels provide a resolution of
2048 × 1080 (horizontal/vertical).
VPL-FW300L: Three WXGA panels with
1,090,000 pixels provide a resolution of
1366 × 800 (horizontal/vertical).
High picture performance
DDE (Dynamic Detail Enhancer)
technology enables conversion of interlace
format video signals to progressive format,
allowing you to obtain a detailed picture.
The technology also reproduces film sources
in 2-3 Pull-Down format with smooth
picture movement. 12-bit 3D Digital
Gamma Correction or 3D Digital Comb
Filter for good picture uniformity is also
provided.
Two-lamp system
Two lamps are equipped. You can select a
desired mode to use two lamps at the same
time or to use one lamp only. When you want
a brighter light or want to use for a long time,
select the appropriate mode.
Stylish round design
The stylish and functional round design
recommends itself as befitting a stylish
interior space.
10
Features
Convenient and flexible setup
Power zoom/power focus and
horizontal/vertical lens shift function
The projector is equipped with power zoom,
power focus and horizontal/vertical lens
shift function which allows you to change
the size of the projected image with the
Remote Commander operated away from
the projector.
The lens is not supplied with this projector.
No lens is supplied with this projector. You
can select a lens suitable for the installation
condition from among many option lenses.
* Only the manual focus adjusting function is
provided for the optional lens VPLL-4008.
Center positioned lens
The projector is designed to locate the lens
in the center of the projector. This enables
easy setup, as the lens center aligns with the
center of the screen.
Cable management
The control/connector panel section is
covered so that the cables will not be visible.
Tilt installation (at front and rear)
You can install the projector by tilting it 90
degrees at the rear or 90 degrees in front.
You can use a mirror for rear projection.
Direct Power On/Off function
The AC power for the entire system can be
turned on and off by means of a breaker or
other switch.
ID function
The function allows you to adjust or control
each projector individually with one Remote
Commander when you use two or more
projectors (up to three) in one room.
Simple maintenance
Even when the projector is mounted on the
ceiling you can change the lamp, the air
filters or the lens easily because the
replacement lamp is located at the rear of the
projector and the air filters are located at the
side.