Table of Contents
Advertisement
The equipment required to validate the environment water sealing on a TP3000 radio is the
Pressure Tester shown below.
Operation
Select the 6 mm test nozzle.
1.
Connect the test nozzle to the end of the pressure tester.
2.
Validate the pressure tester against a flat surface:
3.
Pump in some air.
a.
The pressure should hold and not gradually decrease.
b.
Check the release valve above the pump bulb, it should be closed.
c.
TN-2776h-AN
www.taitradio.com
Page 11 of 16
Advertisement
Table of Contents
