Toro Maxi Sneaker 370 Operator's Manual page 5

1. Grease the shaft of the motor
adapter onto the motor
2. Install the adapter
on the motor.
3. Place the lock washer
apply thread-locking adhesive to the bolt.
4. Secure the bolt to the adapters and torque to
160 to 165 N⋅m (118 to 122 ft-lb).
5. Install 90-degree elbow connectors into the
ports on the motor
6. Secure the motor to the motor bracket using 4
bolts (1/2 x 1-3/4 inches), 4 flat washers (1/2
inch), and 4 locknuts (1/2 inch).
7. Torque the bolts to 91 to 113 N⋅m (67 to 83 ft-
lb).
3462-340A
and place the
and retainer adapter
on the bolt and
Page 2–2
G433933
G433934
G434022
Installation: Installing the Hydra Borer Motor