JVC Everio GZ-RX500 User Manual page 48

Recording
9
Rotate the face slowly in four directions to register the face information.
.
Rotate the face slowly while looking at the camera. A sound can be
0
heard when recording is complete for each direction. (4 times in total)
Repeat the step until recording (registration) is complete for all
directions.
Registration of the four directions may fail depending on the shooting
0
environment. In this case, tap "STOP" to cancel recording, then tap
"NO" and go to step 11.
If the face cannot be properly recognized during recording, register
0
the face again.
10
Face the camera with a smiling face.
.
Recording starts automatically. Using the smile % display as a
0
reference, smile such that the value is as high as possible.
A sound can be heard when recording is complete.
0
To cancel recording of smiling face and proceed to enter a name, tap
0
"STOP", then tap "NO" and go to step 11.
11
Tap "OK".
.
Tapping "OK" registers the recorded face and the screen for entering
0
a name appears.
To cancel the registration, tap "STOP".
0
When "CANCEL FACE RECOGNITION?" appears, tap "YES" to
return to the normal recording mode.
12
Tap on the on-screen keyboard to enter a name, then tap "REG.".
.
Tap "DELETE" to delete a character.
0
Tap "CANCEL" to exit.
0
Tap "A/a/1" to select character input type from upper case letter, lower
0
case letter, and number.
Tap E or F to move one space to the left or right.
0
Up to 8 characters can be entered.
0
How to input characters
0
Example: To enter "KEN"
Tap "JKL" 2 times F Tap "DEF" 2 times F Tap "MNO" 2 times
48
13
Tap the desired priority level, then tap "REG.".
.
Upon registration, the last number is assigned as the priority level.
0
During face detection, the subject with the highest priority (lowest
number) will be detected.
You can change the priority level of a subject by tapping on the
0
number.
Example: To change the priority level of number 3 to number 1, tap
number 1. The priority level of the registered subject becomes
number 1, while the priority levels of the original number 1 and the
ones below drop by one place. (In this example, the original number
1 becomes number 2, and the orignal number 2 becomes number 3.)
When "REG." is tapped, the registration complete screen appears.
0
.
Tap "OK" to complete the registration.
0
You can edit registered face information in "EDIT".
0
"Editing the Registered Face Information" (A p. 50)
Memo :
Faces may not be registered correctly in the following cases:
0
- when the face appears either too small or too large compared to the frame
- when it is too dark or too bright
- when the face appears horizontal or slanted
- when a part of the face is hidden
- when there are multiple faces within the frame
To increase the accuracy of face recognition, fit only one face within the
0
frame and register in a bright environment.
Faces may not be recognized correctly depending on the shooting
0
conditions and environment. In this case, register the face again.
Faces may not be recognized correctly during recording if the face
0
recognition level is low. In this case, register the face again.
Face tracking and name display may not work properly depending on the
0
registered faces, shooting conditions (distance, angle, brightness, etc.),
and expressions.
Face tracking and name display may not work properly for people with
0
similar facial features, such as siblings, parents, children, etc.