JVC Everio GZ-RX500 User Manual page 142

Using Wi-Fi by Creating a QR Code
Regular Operation
o
Connecting the Smartphone to the Camera Wirelessly
Connection by entering the Wi-Fi password
o
1
Tap "MENU".
(Operation on this camera)
Set the camera to the recording mode.
.
The top menu appears.
0
2
Tap the "Wi-Fi" (Q) icon.
(Operation on this camera)
.
3
Tap the "DIRECT CONNECTION" (N) icon in the "Wi-Fi" menu.
(Operation on this camera)
.
When "60p" is selected for "SYSTEM SELECT", the following display
0
appears and recording mode is switched to 60i mode.
This display disappears automatically after approximately 3 seconds,
0
but disappears immediately if the screen is tapped.
.
4
Check the SSID and the PASS being displayed on the screen of the
camera.
.
142
5
Select the SSID in step 4 from the Wi-Fi network selection screen of your
smartphone, and enter the PASS on the password screen.
(Operation on the smartphone)
.
For details on connecting your smartphone to a Wi-Fi network, please
0
refer to the instruction manual of the device in use.
6
A connection is established and Q appears on the camera's screen.
.
Connection by Wi-Fi Protected Setup (WPS)
o
1
Tap "MENU".
(Operation on this camera)
Set the camera to the recording mode.
.
The top menu appears.
0
2
Tap the "Wi-Fi" (Q) icon.
(Operation on this camera)
.
3
Tap the "DIRECT CONNECTION" (N) icon in the "Wi-Fi" menu.
(Operation on this camera)
.
When "60p" is selected for "SYSTEM SELECT", the following display
0
appears and recording mode is switched to 60i mode.
This display disappears automatically after approximately 3 seconds,
0
but disappears immediately if the screen is tapped.