Hotpoint FETC70B Instruction Booklet page 9

Table of Contents

Advertisement

Start and Programmes
Programmes
! If none of the lights are lit; Press the ON/OFF button
Programme
What it does...
Dries your clothes on High Heat
1
setting, ready for wearing.
Cottons
Ready to Wear
Dries your clothes on High Heat
2
setting, ready for putting away.
Standard
Cotton
Dries your clothes on Low Heat
3
setting, ready for putting away.
Synthetics
Cupboard dry
Brief programme (approximately
4
10 minutes) that softens fibres of
Easy Iron
clothing that is ready for ironing.
5
Brief programme (approximately
10 minutes) that cools fibres of
Cool Tumble
clothing.
Dries wet clothing that you wish
Timed Drying
to dry on Low Heat or small
(150, 140, 120,
loads (less than 1kg).
100, 80, 70, 60,
50, 40, 30 or 20
Can be used with High Heat
minutes)
option if you prefer to use a
timed programme.
2
Standard Cotton
This is a programme for cotton items.
The duration of this programme will depend on the size of the load, the dryness setting selected and the spin
speed used in your washer (see Laundry).
The Standard Cotton programme to EU Regulation 392/2012 is Programme 1 selection with High Heat and
Dryness Level Cupboard Dry
energy consumption (EU 392/2012).
4
Easy Iron Programme
'Easy Iron' is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which
fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The
cycle relaxes the fibres and makes them easier to iron and fold.
! 'Easy Iron' is not a drying programme and should not be used for wet articles of clothing.
For best results:
1. Do not load more than the maximum capacity.
These numbers refer to the dry weight:
Fabric
Cotton and Cotton mixtures
Synthetics
Denim
2. Unload the dryer immediately after the end of the programme, hang, fold or iron the articles and put
them away in the closet. Should this not be possible repeat the programme.
The 'Easy Iron' effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton
mix, and less well on acrylic fibres and on materials such as Tencel®.
and then select programme.
How to set it...
1. Position the PROGRAMMES knob
on
.
2. Select any options if required.
3. Press the Start/Pause button
1. Position the PROGRAMMES knob
on
.
2. Select any options if required.
3. Press the Start/Pause button
1. Position the PROGRAMMES knob
on
.
2. Select any options if required.
3. Press the Start/Pause button
1. Position the PROGRAMMES knob
on
.
2. Press the Start/Pause button
1. Position the PROGRAMMES knob
on
.
2. Press the Start/Pause button
1. Position the PROGRAMMES knob
on the desired time: 150, 140, 120,
100, 80, 70, 60, 50, 40, 30 or 20.
2. Select any options if required.
3. Press the Start/Pause button
(the standard/default configuration). This is the most efficient programme in terms of
Maximum load
2.5kg
2kg
2kg
Note:
Options available:
Delay Timer
Pre Care
Post Care
Options available:
Delay Timer
Pre Care
Post Care
Options available:
Delay Timer
Pre Care
Post Care
! This is not a drying
programme (see previous
page).
Options available:
None
Options available:
None
Options available:
High Heat
Delay Timer
Pre Care
Post Care
Consult 'suggested drying
times' (see Laundry).
The last 10 minutes of these
programmes is the Cool
Tumble phase.
GB
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdn7000bTchl 73

Table of Contents