Advertisement
Quick Links
Instruction booklet
TUMBLE DRYER
Important Information
PRODUCT DATA... (EU Regulation 392/2012)
Rated capacity of Cotton laundry for the standard programme at full load 7 kg
The weighted Annual Energy Consumption (AE
Consumption per year, based on 160 drying cycles of the standard cotton programme at full and partial load, and the consumption of
the low-power modes. Actual energy consumption per cycle will depend on how the appliance is used
This household tumble dryer is a Non-Automatic Condenser Dryer
Energy consumption: full load E
Power consumption: off-mode (P
Duration of the 'left-on mode' for power management systems - N/A minutes
The 'standard cotton programme' suitable for drying normal wet cotton laundry that is the most efficient programme in terms of
energy consumption for cotton used at full and partial load is High Heat
Programme time (minutes) weighted (T
Condensation efficiency class C
Average condensation efficiency (%): full load (C
Airborne acoustical noise emissions 69 dB(A) re 1 pW.
This data is also available on the website http://www.hotpoint.eu/hotpoint
This symbol reminds you to read this booklet.
FLUFF FILTER
You must clean the fluff filter after
Step 1
Open the door of your dryer.
(To open the door Press and Re-
lease the right hand of the front
panel)
Step 2
Pull out the filter (using the two
finger grips).
Step 3
Clean any fluff deposits from the
filter mesh.
!
You MUST empty the water container after EVERY drying cycle.
Failure to empty the water container will cause the machine to stop heating and the load may still be wet at the end of the
drying cycle. The 'Empty Water' light will tell you that the water container is full and needs emptying.
CDN 7000
FETC 70C
) 563.2 kWh.
c
4.77 kWh, partial load E
dry
dry1/2
) 0.00 W
o
) full & partial load 97, full load (T
t
) 70, partial load (C
dry
EVERY
2.59 kWh
) 128, partial load (T
dry
) 71, weighted (C
) full & partial load 71
dry1/2
t
drying cycle.
Step 4
Refit the filter.
Step 5
Make sure the filter is pushed fully home -
without the filter in position.
!
Failure to clean the filter after EVERY drying cycle will affect
the drying performance of your machine.
It will take longer to dry and as a result will use more
electricity during drying.
Energy efficiency class C
) 73
dry1/2
NEVER
run the dryer
Advertisement
Related Manuals for Hotpoint CDN 7000
Summary of Contents for Hotpoint CDN 7000
-
Page 1: Important Information
) 71, weighted (C ) full & partial load 71 dry1/2 Airborne acoustical noise emissions 69 dB(A) re 1 pW. This data is also available on the website http://www.hotpoint.eu/hotpoint This symbol reminds you to read this booklet. FLUFF FILTER EVERY You must clean the fluff filter after drying cycle. -
Page 2: Water Container
Installation WATER CONTAINER MUST empty the water container EVERY after drying cycle. WHERE TO PUT YOUR DRYER Removing the water container: If you are going to install the dryer under a work counter be sure to leave Step 1 a 10mm space between the top and Pull the water container towards you and remove it completely any other objects on or above the from the dryer. -
Page 3: Choosing A Programme
CHOOSING A PROGRAMME WASH CARE LABELS 1. Plug the dryer into the electrical socket. Look at the labels on your garments when tumble drying. The following symbols are the most common. 2. Sort your laundry according to fabric type. 3. Open the door and make sure the filter is clean and in place. May be tumble dried 4. -
Page 4: Warnings And Suggestions
(Electromagnetic Compatibility) Essential Contact Information 11/2013 - Xerox Fabriano HOTPOINT SERVICE Please note: Our advisors will require the following information: We are the largest service team in the country offering you access to 400 skilled telephone advisors and 1100 fully qualified MODEL NUMBER engineers on call to ensure you receive fast, reliable, local service.
Need help?
Do you have a question about the CDN 7000 and is the answer not in the manual?
Questions and answers
The dryer works perfectly as normal except that the water collector remains empty even after drying a towel load. This only started happening recently.
The water collector in a Hotpoint CDN 7000 dryer could remain empty after drying a towel load if the water collection system has not yet been primed. When the dryer is new, it may take 1 or 2 drying cycles before the system starts collecting water.
This answer is automatically generated