Advertisement
3. Push the 2-way tab housing connector onto the
terminals of the number plate cable
Figure 11
1. Red wire
2. Black wire
4. Connect the number-plate-light wiring to either the
left or right rear-light-assembly-wiring, 2-pin electrical
connector.
5. Plug the flasher relay into the left vacant-relay socket
and the standard shorter relay into the right vacant-relay
socket
(Figure
12).
Figure 12
1. Flasher relay
(Figure
11).
3. 2-way tab housing
connector
1
2
g018246
2. Standard shorter relay
5
Installing the Front Lights
Parts needed for this procedure:
g028150
1
Center headlight mount
1
Right headlight mount
1
Left headlight mount
8
Bolt (M6 x 20 mm)
8
Locknut (M6)
4
Bolt (M10 x 25 mm)
4
Locknut (M10)
8
Washer (3/8 inch)
2
Mounting bracket
2
4-way tab housing connector
Procedure
The front light assemblies attach to the center headlight
mount, which attaches to the machine using two mounting
brackets
(Figure
13):
1. Install the 2 mounting brackets to the front of the
machine using 2 bolts (M10 x 25 mm), 4 washers (3/8
inch), and 2 locknuts (M10) as shown in
2. Install the center headlight mount to the mounting
brackets using 2 bolts (M10 x 25 mm), 4 washers (3/8
inch), and 2 locknuts (M10) as shown in
3. Apply anti-seize grease to fully coat the inside wall of
the tube ends and all the surfaces of the springs and
tube-end profiles
4. While holding the right headlight mount, thread the
wiring cable down through the end tubes and out from
g018246
the headlight mount cutout
5. Secure the right headlight mount to the center headlight
mount using the 4 bolts (M6 x 20 mm) and 4 locknuts
(M6) as shown in
7
Figure
Figure
(Figure
13).
(Figure
13).
Figure
13.
13.
13.
Advertisement
