Page 1
AIR-OPERATED DOUBLE DIAPHRAGM PUMP OWNER’S MANUAL ITEM# 41763 ITEM# 41769 WARNING: Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the safety rules and other basic safety precautions may result in serious personal injury. Item#s41763, 41769...
Thank you very much for choosing a Roughneck® Product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________ Save the receipt, warranty and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it.
MODEL: 41763 MODEL: 41769 GENERAL SAFETY REGULATIONS WARNING: Read and understand all instructions. WARNING: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur. It must be understood by the operator that common sense and caution are factors that cannot be built into this product, but must be supplied by the operator.
1. Keep the work area clean and dry.Damp or wet work areas can result in injury. 2. Keep children away from work area. Do not allow children to handle this product. 3. Store idle equipment. When not in use, tools and equipment should be stored in a dry location to inhibit rust.
◼ In the event of a diaphragm rupture material can be forced out of the air exhaust muffler. ◼ Pipe the exhaust to a safe remote location when pumping hazardous or inflammable materials. WARNING! HAZARDOUS PRESSUREcan result in serious injury or property damage. Do not service or clean pump, hoses or dispensing valve while the system is pressurized.
TROUBLE SHOOTING Product discharged from exhaust outlet. • Check for diaphragm rupture • Check tightness of diaphragm Air bubbles in product discharge. • Check connections of suction plumbing • Check O-rings between intake manifold and fluid caps • Check tightness of diaphragm nut Low output volume, erratic flow, or no flow.
AIR MOTOR SECTION Q’ty Q’ty Part Description Part Description Hex-bolt M6X20 O-ring 7.1X2.65 Press board Pilot Valve Seal for press board O-ring 6.86X1.78 O-ring 13.94x2.62 Muffler 3/8" Hex bolt M5X12 O-ring 15.60X1.78 Gasket Spacer Seal for gasket Spacer Washer Spacer Sleeve O-ring 13.94X2.62 O-ring 20.35X1.78...