Subscribe to Our Youtube Channel
Related Manuals for Billi OmniOne Pro
Summary of Contents for Billi OmniOne Pro
- Page 1 Commercial User Guide Billi OmniOne Pro & Billi OmniOne Plus Dispenser Options: XL and Mixer Tap, AL (926060, 926065)
-
Page 2: Table Of Contents
- WARNING: Internal surfaces adjacent to and directly in contact with the heating element are subject to residual heat after use. All-in-One Mixer Tap Icons - Only Billi hose and tube kits as supplied with the appliance are to be used. Old or other manufacturer’s hose and tube kits should not be used. -
Page 3: Warnings And Important Information
Use this appliance only as directed in these instructions and only for the purpose for which it has been designed. Your Billi OmniOne is designed to be safe and practical. In an environment with young children, it is recommended that the boiling water WARNING: safety switch is activated. -
Page 4: Co 2 Warnings
The Home Screen remains visible when locked, however no screen input functions will operate. To unlock touch anywhere on the Home Screen to go to the Billi Landing Screen, then press the hidden button on the top right corner of the Billi Landing Screen. -
Page 5: Energy Saving Modes
Dispenser Features Your Billi OmniOne features various energy saving modes that can be activated to reduce energy consumption during periods of non-use. These modes can be customised to best suit your usage patterns and requirements, and can all be used in conjunction with each other. -
Page 6: Set Up Instructions
Use only Billi genuine filters designed for this system. All drinking water systems should be flushed after a period of non-use. Your Billi Current status may be displayed as follows in the additional status box: OmniOne has an automatic flushing cycle which is switched on by default to flush the system for 90 seconds after 48 hours of non-use. -
Page 7: Filter Change Reminders
If particularly dirty water is noticed coming through the water supply (e.g. from other tapware), as sometimes occurs following repairs to local water mains, immediately turn your Billi OmniOne off at the power source and shut water supply to the system if possible. This will help 6. -
Page 8: Co2 Cylinder Removal
8. Increase the pressure to set your level of carbonation. contact with the cold escaping gas as per the Material • Initial set pressure may vary once the Billi OmniOne is running. You Safety Data Sheet included with the CO cylinder. -
Page 9: Billi Omnione Plus 9
Billi® is a registered trademark of Billi Australia Pty Ltd. Billi OmniOne™ is trademark of Billi Australia Pty Ltd. All rights reserved. © Copyright protected. Billi Australia Pty Ltd has a policy of continual improvement, all details are subject to change without notice. All goods are sold subject to our published terms and conditions.
Need help?
Do you have a question about the OmniOne Pro and is the answer not in the manual?
Questions and answers