Subscribe to Our Youtube Channel
Related Manuals for Billi OmniOne Pro
Summary of Contents for Billi OmniOne Pro
- Page 1 Commercial Installation Guide Billi OmniOne Pro & Billi OmniOne Plus Dispenser Options: XL and Mixer Tap (926060, 926065)
-
Page 2: Table Of Contents
- WARNING: Internal surfaces adjacent to and directly in contact with the heating element are subject to residual heat after use. - Only Billi hose and tube kits as supplied with the appliance are to be used. Old or other manufacturer’s hose and tube kits should not be used. -
Page 3: Unpacking Your Billi Omnione
Large D-washer The Billi OmniOne must only be connected to a cold water supply. A 1/2” BSP stop tap (not supplied) is to be installed in an easily accessible location within 600mm of the Billi OmniOne water supply inlet. A certified pressure limiting valve with internal dual check valve for backflow prevention is incorporated in the appliance. Do Determine Dispenser Location not fit an additional pressure limiting valve or dual check valve. -
Page 4: Installing Underbench Module
Connect Dispenser Tubing and Power Cord for clarity removed Connect dispenser power cord and tubing as shown in Diagram 10 and 11. For Billi OmniOne Plus 9 refer to instructions on page 9 for Plus mixer for clarity 35mm 70mm tap installation. -
Page 5: Installing The Plus Mixer Tap (Billi Omnione Plus 9 Only)
Operation of mixer tap is as with any single lever mixer tap. Lift lever to start water flow. Swing lever to adjust water temperature as indicated on lever. Hot water will not be available until the Billi OmniOne boiling water tank has filled and is heated to temperature. Bubbling in the hot water flow indicates insufficient boiling water is available. -
Page 6: Commissioning
The display will first request for boiling point calibration confirmation, press “Confirm” when this is displayed. (PVC Tube) The Billi OmniOne will now carry out the automatic commissioning sequence. This involves various flush and fill sequences, along with automatic calibration of boiling water temperature. Cold water will dispense from the dispenser, along with CO gas. -
Page 7: Installation And Commission Checklist
Billi® is a registered trademark of Billi Australia Pty Ltd. Billi OmniOne™ is trademark of Billi Australia Pty Ltd. All rights reserved. © Copyright protected. Billi Australia Pty Ltd has a policy of continual improvement, all details are subject to change without notice. All goods are sold subject to our published terms and conditions.
Need help?
Do you have a question about the OmniOne Pro and is the answer not in the manual?
Questions and answers